Indesit OS 992 C IX /HA Bedienungsanleitung PDF herunterladen (Seite 23)

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

 The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

 The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

 All accessories - with the exception of the sliding

racks - can be washed like everyday crockery,

and are even dishwasher safe.

 Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small

levers F located on the two hinges (see diagram).

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you lifting it

out of its seat (see diagram).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven at regular

intervals. If the seals are damaged, please contact

your nearest After-sales Service Centre (see

Assistance). We recommend that the oven is not

used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the

glass cover of the

lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

halogen lamp

voltage 230 V,

wattage 25 W,

cap G 9.

3. Replace the glass cover (see diagram).

 Do not touch the light bulb directly with your

hands.

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames,

lifting them away from the

spacers A (see figure).

2. Choose which shelf to use

with the sliding rack. Paying

attention to the direction in

which the sliding rack is to be

extracted, position joint B and

then joint C on the frame.

3. Secure the two frames with

the guide rails using the holes

provided on the oven walls

(see diagram). The holes for

the left frame are situated at

the top, while the holes for the

right frame are at the bottom.

4. Finally, fit the frames on the spacers A.

Left

guide rail

Right guide

rail

Direction

of e

xtraction

Glass door

Lamp

Oven

compartment

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit OS 992 C IX /HA Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit OS 992 C IX /HA