Indesit CI3V P67(X) RU/HA Bedienungsanleitung PDF herunterladen (Seite 15)

to each other; jumper 4-5 is located in the lower area

of the terminal board.

3. Position the wires N and

as shown in the

diagram (

see figure

) and proceed with the

connection process, tightening the terminal screws

as far as possible.

4. Position the remaining wires on terminals 1-2-3

and tighten the screws.

5. Fix the power supply cable in place by fastening

the cable clamp screw.

6. Close the terminal board cover by tightening the

screws V.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the appliance data plate (

see

Technical data table

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the

appliance and the mains. The circuit-breaker must be

suitable for the charge indicated and must comply with

NFC 15-100 regulations (the earthing wire must not be

interrupted by the circuit-breaker). The supply cable

must be positioned so that it does not come into

contact with temperatures higher than 50°C at any point.

Before connecting the appliance to the power

supply, make sure that:

• The appliance is earthed and the plug is compliant

with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated by the data

plate.

• The voltage is in the range between the values

indicated on the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only.

! The manufacturer declines any liability should

these safety measures not be observed.

Only available in certain models.

TABLE OF CHARACTERISTSICS

Dimensions

Oven HxDxW

34x41x38

Volume

53 l

Useful

measurements

relating to the oven

compartment

width 42 cm

depth 44 cm

height 17 cm

Voltage and

frequency

see data plate

Ceramic hob

Front Left

Back Left

Back Right

Front Right

Max. ceramic hob

consumption

1200 W

1800 W

1200 W

1800 W

6000 W

ENERGY LABEL

Directive 2002/40/EC on the label of

electric ovens.

Standard EN 50304

Energy consumption for Natural

convection – heating mode:

Traditional mode;

Declared energy consumption for

Forced convection Class – heating

mode:

Baking mode.

This appliance conforms to the following

European Economic Community

directives: 2006/95/EC dated 12/12/06

(Low Voltage) and subsequent

amendments - 04/108/EC dated

15/12/04 (Electromagnetic

Compatibility) and subsequent

amendments - 93/68/EEC dated

22/07/93 and subsequent amendments.

2002/96/EEC

1275/2008 (Stand-by/ Off mode)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit CI3V P67(X) RU/HA Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit CI3V P67(X) RU/HA