Indesit KN6G21S(WX)/P S Bedienungsanleitung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 36
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
GB
11
Using the hob
Lighting the burners
For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting C, the
maximum setting E or any position in between the two.
If the appliance is fitted with an electronic lighting
device* (see  gure), press the
ignition button, marked with
the symbol
1
, then hold the
BURNER knob down and turn
it in an anticlockwise direction,
towards the maximum flame
setting, until the burner is lit.The
burner may be extinguished
when the knob is released. If this occurs, repeat the
operation, holding the knob down for a longer period of
time.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.
If the appliance is equipped with a flame failure
safety device*, press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
the stop position
•.
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed, it
is recommended that only pans that have a lid and a flat
base are used. They should also be suited to the size of
the burner.
Start-up and use
To
identify the type of burner, please refer to the diagrams
contained in the “Burner and nozzle specifications”.
! On the models supplied with a reducer shelf, remember
that this should be used only for the auxiliary burner when
you use casserole dishes with a diameter under 12 cm.
Using the oven
! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature for
at least half an hour. Ensure that the room is well ventilated
before switching the oven off and opening the oven door.
The appliance may emit a slightly unpleasant odour caused
by protective substances used during the manufacturing
process burning away.
! Never put objects directly on the bottom of the oven; this
will avoid the enamel coating being damaged.
Lighting the oven
To light the oven burner, bring a flame or gas lighter close to
opening F (see  gure) and press the OVEN control knob while
turning it in an anticlockwise direction until it reaches the
MAX position.
If the appliance is fitted with an electronic lighting device*
(see figure), simply press the
OVEN control knob and turn it in an
anticlockwise direction, towards the
MAX position, until the burner is lit.
If, after 15 seconds, the burner is still
not alight, release the knob, open
the oven door and wait for at least 1
minute before trying to light it again. If
there is no electricity the burner may be lit using a flame or a
lighter, as described above.
! The oven is fitted with a safety device and it is therefore
necessary to hold the OVEN control knob down for
approximately 6 seconds.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting to
relight the oven.
*
Only available in certain models.
F
WARNING! The glass lid can break in if
it is heated up. Turn off all the burners
and the electric plates before closing
the lid. *Applies to the models with glass
cover only.
Burner ř Cookware diameter (cm)
Rapid (R) 24 - 26
Semi-Rapid (S) 16 - 20
Auxilliary (A) 10 - 14
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare