Indesit FHS G IX/HA Bedienungsanleitung PDF herunterladen (Seite 3)

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal board by

inserting a screwdriver into the

side tabs of the cover. Use

the screwdriver as a lever by

pushing it down to open the

cover (see diagram).

2. Install the power supply

cable by loosening the cable

clamp screw and the three

wire contact screws L-N-

Connect the wires to the

corresponding terminals: the

Blue wire to the terminal

marked (N), the Brown wire to

the terminal marked (L) and

the Yellow/Green wire to the

terminal marked

(see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate (see adjacent box).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains. The circuit-breaker

must be suitable for the charge indicated and must

comply with current electrical regulations (the

earthing wire must not be interrupted by the circuit-

breaker). The supply cable must not come into

contact with surfaces with temperatures higher than

50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure

that:

• the appliance is earthed and the plug is compliant

with the law.

• the socket can withstand the maximum power of

the appliance, which is indicated on the data

plate (see below).

• the voltage is in the range between the values

indicated on the data plate (see below).

• the socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

Gas connection

The appliance should be connected to the main gas

supply or to a gas cylinder in compliance with

current National regulations. Before carrying out the

connection, make sure the cooker is compatible with

the gas supply you wish to use.

When using liquid gas from a cylinder, install a

pressure regulator that complies with current

National regulations.

! Check that the pressure of the gas supply is

consistent with the values indicated in Table 1

(“Burner and nozzle specifications”) since this will

ensure the safe operation and longevity of your

appliance while maintaining efficient energy

consumption.

! Should you need to install a gas hob on top of a

built-in gas oven, it is strictly forbidden to connect

the two or to use a single cut-off tap. The two

appliances should be connected separately, and

each one should have its own stop tap in order to

make them completely independent from one

another (see figures).

Connection with a rigid pipe (copper or steel)

! Connection to the gas system must be carried out

in such a way as not to place any strain of any kind

on the appliance.

1 2 3 4 5 6 7 8 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FHS G IX/HA Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Indesit FHS G IX/HA