Indesit LSB 7M121 W EU Bedienungsanleitung PDF herunterladen (Seite 26)

Rinse aid and refined salt

Only use products which have been specifically designed

for dishwashers.

Do not use table/industrial salt or washing-up liquid.

Follow the instructions given on the packaging.

If using a multi-functional product it is not necessary to add

any rinse aid. However, we recommend that you add salt,

especially if you live in an area where the water is hard or

very hard.

(Follow the instructions given on the packaging).

If you do not add salt or rinse aid, the LOW SALT* and

LOW RINSE AID indicator lights will stay lit.

Measuring out the rinse aid

Rinseaidmakesiteasierforthecrockerytodry,aswaterrunsoff

the surfaces more readily and therefore does not leave streaks

or marks. The rinse aid dispenser should be filled:

• WhentheLOWRINSEAIDindicatorlight* on the control panel

is illuminated, a reserve supply of rinse aid is still available

for1-2cycles;

1.Openthedispenser“D” by pressing and pulling up the tab

on the lid;

2.Carefully introducethe rinse aid as faras the maximum

reference notch of the filling space - avoid spilling it. If this

happens, clean the spill immediately with a dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the appliance tub.

Rinse-aid dispenser setting

f you are not completely satisfied with the drying results, you can

adjustthequantityofrinseaid.Switchthedishwasheronandoff

using the ON/OFF button. Press the Start/Pause button 3 times.

Start it using the ON/OFF button. The rinse-aid indicator light

will flash as many times as the level that was set

(set to factory

level).

Adjustthelevelofrinseaidsupply using the SELECT

WASHCYCLEknob.

Press the ON/OFF button to save the setting.

IftherinseaidlevelissettoZERO(ECO),norinseaidwillbe

supplied.TheLOWRINSEAIDindicatorlightwillnotbelitifyou

run out of rinse aid.

Up to maximum 4 levels can be set based on the dishwasher

model.

• Iftherearestreaksonthecrockery,settheadjustmentdevice

toalowernumber(1-2).

• If there aredrops of water or limescale marks, set the

adjustmentdevicetoahighernumber(3-4).

Setting the water hardness

Everydishwasherisequippedwithawatersoftenerusingrefined

salt designed specially for this type of appliance in order to

supply water without limescale for crockery washing.

This dishwasher has a setting that helps reduce pollution and

optimises washing performance in accordance with the water

hardness level in your area. Ask your local water supplier for

this information.

Switch the dishwasher on and off using the ON/OFF button.

Press and hold down the Start/Pause button for a few seconds

until you hear a beep*. Switch the dishwasher on using the

ON/OFF button. The salt indicator light will flash as many times

as the level that was set

(water softener set to medium level).

AdjustthehardnesslevelusingtheSELECTWASHCYCLEknob

(1-2-3-4-5* see the water hardness table)

up to max. 5 levels.

Press the ON/OFF button to save the setting.

Evenifusingmulti-functionaltablets,fillthesaltdispenser.

(°dH=hardnessmeasuredinGermandegrees-°f=hardness

measuredinFrenchdegrees–mmol/l=millimolesperlitre)

Measuring out the refined salt

In order to obtain the best possible results from a wash cycle,

make sure that the salt dispenser is never empty.

Refinedsaltremoveslimescalefromthewater,thusavoiding

the formation of deposits on crockery.

The salt dispenser is located in the lower part of the dishwasher

(see Description)

and should be filled:

• Whenthegreenfloat* cannot be seen by simply looking at

the cap of the salt dispenser;

• WhentheLOWRINSEAIDindicatorlightonthepanel/display

is illuminated *;

1.Removethelowerrackandunscrewthecap(anticlockwise).

2.Thefirsttimeyoudothis:fillthewatertankrightuptoitsedge.

3. Position the funnel*

(see figure)

and fill the salt dispenser up to

theedge(approximately1kg).Itisnormal

for a little water to leak out.

4.Removethefunnel*andwipeanysalt

residues away from the opening; rinse the

cap under running water and then screw

it on, the head facing downwards so as

to let the water flow out of the four slots

(star-shaped arrangement) in the lower part of the cap (cap

with green float*).

It is advisable to perform this procedure every time you add

salt to the dispenser.

Make sure the cap is screwed on tightly so that no detergent can

get into the container during the wash cycle (this could damage

the water softener beyond repair).

Whennecessary,measureoutthesaltbeforeawashcycle

so that any saline solution which has leaked out of the salt

dispenser is removed.

* Only available in selected models.

Water Hardness Table

Average salt dispenser

capacity duration**

level °dH °fH mmol/l months

1 0 - 6 0 - 10 0 - 1

7 months

2 6 - 11 11 - 20 1,1 - 2

5 months

3 12 - 17 21 - 30 2,1 - 3

3 months

4 17 - 34 31 - 60 3,1 - 6

2months

34 - 50 61 - 90 6,1 - 9

2/3weeks

Forvaluesbetween0°fand10°f,wedonotrecommendtheuseofsalt.

* a setting of 5 may increase cycle duration.

** 1washcycleperday.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit LSB 7M121 W EU Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Indesit LSB 7M121 W EU