Indesit K6C10(W)/R S Bedienungsanleitung PDF herunterladen (Seite 19)

! Before operating your new appliance please read

this instruction booklet carefully. It contains important

information concerning the safe installation and

operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept with

the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified

professional in accordance with the instructions

provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning and levelling

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the bed-sit

(not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm away

from them.

• If the cooker is

installed underneath a

wall cabinet, there must

be a minimum distance

of 420 mm between this

cabinet and the top of

the hob.

This distance should be

increased to 700 mm

if the wall cabinets are

flammable (see  gure).

• Do not position blinds behind the cooker or less than

200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the appliance, screw the

adjustable feet into the places

provided on each corner of the

base of the cooker (see  gure).

The legs* fit into the slots on the

underside of the base of the

cooker.

Electrical connection

Fitting the power

supply cable

To open the terminal

board:

• Insert a screwdriver

into the side tabs of the

terminal board cover.

• Pull the cover to

open it.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire contact

screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection (see  gure).

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box (see

 gure - labelled “P”).

Installation

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.

Only available in certain models.

230V ~

H05RR-F 3x4 CEI-UNEL 35363

H05VV-F 3x4 CEI-UNEL 35746

NL2L1

400V 2N~

H05RR-F 4x4 CEI-UNEL 35363

H05VV-F 4x4 CEI-UNEL 35746

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit K6C10(W)/R S Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit K6C10(W)/R S