Indesit CISFBG (WH) /HA Bedienungsanleitung PDF herunterladen (Seite 3)

Ventilation

To ensure adequate ventilation, the back panel of

the cabinet must be removed. It is advisable to

install the oven so that it rests on two strips of wood,

or on a completely flat surface with an opening of at

least 45 x 560 mm (see diagrams).

Centring and fastening

Position the 4 tabs on the side of the oven according

to the 4 holes on the outer frame. Adjust the tabs

according to the thickness of the cabinet side panel,

as shown below:

20 mm thick: take off the

removable part of the tab (see

diagram).

18 mm thick: use the first

groove, which has already

been set in the factory (see

diagram).

16 mm thick: use the second

groove (see diagram).

Secure the appliance to the cabinet by opening the

oven door and fastening 4 screws into the 4 holes of

the outer frame.

 All parts ensuring the safe operation of the

appliance must not be removable without the aid of

a tool.

Electrical connections

 Ovens equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the screwdriver as

a lever by pushing it

down to open the cover

(see diagram).

2. Loosen the cable

clamp screw and

remove it, using a

screwdriver as a lever

(see figure).

3. Remove the wire

contact screws L-N-

, then fasten the wires

under the screw heads,

respecting the colour

code: Blue (N), Brown

(L) and Yellow-Green

Verde (

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate (see adjacent box).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains. The circuit-breaker

must be suitable for the charge indicated and must

comply with current electrical regulations (the

earthing wire must not be interrupted by the circuit-

breaker). The supply cable must not come into

contact with surfaces with temperatures higher than

50°C.

 The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure

that:

 the appliance is earthed and the plug is compliant

with the law.

45 mm

1 2 3 4 5 6 7 8 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit CISFBG (WH) /HA Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit CISFBG (WH) /HA