Indesit KOT 7424 IO (BI) 400 Bedienungsanleitung PDF herunterladen (Seite 13)

Connecting the hob

 The electrical safety of this appliance can only be

guaranteed if the latter is correctly and efficiently

earthed, in compliance with regulations on

electrical safety. Always ensure that this vital

safety measure has been taken. If you have any

doubts, call in a qualified technician to check the

electrical system thoroughly.

 The manufacturer denies all responsibility for

damage resulting from a system which has not

been earthed correctly.

 Before powering the appliance, check whether the

technical characteristics featured on the appliance

data plate correspond with those of the mains

electrical system.

 Check that the current load of the mains supply

and of the power sockets is suitable for the

maximum power of the appliance, indicated on

the appliance data plate. If in doubt, contact a

qualified professional.

Disconnect the appliance from the electricity

supply before all operations.

Connect your hob to the electrical system by means

of a

junction box:junction box:

junction box: if the appliance is connected

permanently to the mains, an

omnipolar circuitomnipolar circuit

omnipolar circuit

breakerbreaker

breaker, accessible if necessary, with a minimum

contact opening of 3 mm should be installed.

Valid only for models with a power supply

cable

Some models are supplied with a single-phase

power supply cable, and should consequently only

be connected to the single-phase mains. Observe

the wire colours, as indicated in the diagram

attached.

Valid only for models without a power supply

cable

Some models are not fitted with a power supply

cable, as the cable should be sized according to the

type of electrical connection in use (see connection

table below). To connect the cable, proceed as

follows:

1. Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the screwdriver as

a lever by pushing it

down to open the cover

(see diagram).

2. Loosen the cable

clamp screw and

remove it, using a

screwdriver as a lever

(see figure).

3. Remove the wire

contact screws L-N-

, then fasten the wires

under the screw heads,

respecting the colour

code: Blue (N), Brown

(L) and Yellow-Green

Verde (

 to make the desired electrical connection (see

table), use the jumpers housed inside the box.

Position the power supply cable wires according

to the indications in the table.

 once the connections have been made, tighten all

the terminal screws fully.

 Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

Electrical connections Voltage, Frequency Fuses, Sections

FR-BE-AT-DE-GR-ES-IL-

IT-NZ-PT-GP-CH-MA-LU-

IE-FI-SE-IS-GB-NL-DK

230V - 1+N~ 50Hz

CY-MT-AU-NZ-KW

240V - 1+N~ 50Hz

25A *

2,5 mm²

FR-BE-NO

230V - 2 ~ 50Hz

BR=BRUN,BL=BLEU

BR=BRUIN, BL=BLAUW

BR=BRAUN, BL=BLAU

BR=BROWN, BL=BLUE

* Application of the simultaneity coefficient in accordance with

cei 60335-2-6 norm

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit KOT 7424 IO (BI) 400 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Indesit KOT 7424 IO (BI) 400