Indesit IDCE 845 A ECO (EU) Bedienungsanleitung PDF herunterladen (Seite 39)

Starting and selecting a programme

1. Plug the dryer into the power supply socket.

2. Select the programme according to the type of laundry (see Laundry).

3. Open the door, ensure that the filter is clean and securely placed and that the water container is empty and correctly slotted (see

Maintenance).

4. Load the machine, making sure that no piece of laundry gets between the door and the relative seal. Close the door.

5. Press the ON/OFF button to start the machine.

6. After consulting the programme chart and the indications for each type of fabric (see Laundry), turn the Programme selection

knob towards the programme corresponding to the type of laundry to be dried (see Programmes and options).

! Warning: If the position of the programme selection knob changes after pressing the START/PAUSE button, the selected program-

me will NOT be modified. To modify the programme, press the START/PAUSE button to put the programme in pause mode (the

indicator light flashes orange), then select a new programme and the relative options. Press the START/PAUSE button to start the

new programme.

7. Select the ”Timed Drying” function by pressing the timed drying button until the required time is dispayed (see Programmes and

options).

8. If necessary, set the time of the delayed start and any other options (see Programmes and options).

9. Press the ALARM

button to sound a buzzer signalling the end of the programme.

10. Press the START/PAUSE button to start the drying cycle. The display will show the approximate time remaining.

Laundry can be checked while the drying programme runs and any garments already dry can be removed, while drying continues

for the remaining items. After closing the door, press the START/PAUSE button to resume machine operation.

If you open the door to check your laundry you will extend the drying time as the heat pump compressor will not start until 5 minutes

after you close the door and pressed the start Button.

11. The final COOL TUMBLE phase (i.e. the fabrics are cooled) activates during the last few minutes of the drying programme;

always allow this phase to terminate.

12. At the end of the drying cycle the display shows END.

The buzzer will beep 3 times to let you know that your programme is complete. (Note: If the SOUND option was selected the buzzer

beeps 3 times every 30 seconds for 5 minutes).

Open the door, remove the laundry then clean the filter and replace it. Empty the water container and put it back in its slot (see

Maintenance).

If the “Post anti-crease” option was selected and laundry is not removed immediately, the drum will rotate garments at intervals for

10 hours or until the door is opened. If the “Post anti-crease” option was selected and laundry is not removed immediately, the drum

will rotate garments at intervals for 10 hours or until the door is opened.

13. Disconnect the dryer from the power supply.

Standby mode

This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system which is enabled

after about 30 minutes if no activity is detected. Press and hold the ON/OFF button until the dryer reactivates.

How to carry out a

drying cycle

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

Keine Kommentare

Indesit IDCE 845 A ECO (EU) Bedienungsanleitung Seite 39