Indesit KN6I66A(W)/FR S Bedienungsanleitung PDF herunterladen (Seite 22)

! Please keep this instruction booklet in a safe place

for future reference.. Make sure the booklet remains

with the appliance if it is sold, given away or moved.

! Please read this manual carefully: it contains

important information on installation, operation and

safety.

! The appliance must be installed by a qualified

professional in accordance with the instructions

provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning and levelling

! The appliance may be installed alongside any

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall which is in contact with the

back of the appliance is made from a non-

flammable, heat-resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the

studio flat (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm

away from them.

• If the cooker is installed underneath a wall cabinet,

there must be a minimum distance of 420 mm

between this cabinet and the top of the hob.

This distance should

be increased to 700

mm if the wall cabinets

are flammable (

see

figure

• Do not position

blinds behind the

cooker or less than 200

mm away from its

sides.

• Any hoods must be installed in accordance with

the instructions listed in the relevant operating

manual.

Levelling

If it is necessary to level the

appliance, screw the

adjustable feet into the

positions provided on each

corner of the base of the

cooker (

see figure

The legs* fit into the slots on

the underside of the base of

the cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the

terminal board cover.

• Pull the cover to

open it.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire

contact screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection (

see figure

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box

(

see figure

- labelled “P”).

Installation

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.

230V ~

H05RR-F/ 3x4 CEI-UNEL 35363

H05VV-F/ 3x4 CEI-UNEL 35746

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit KN6I66A(W)/FR S Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Indesit KN6I66A(W)/FR S