Indesit FH 83 C (BK)/HA S Bedienungsanleitung PDF herunterladen (Seite 24)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack. For more thorough cleaning purposes, the oven

door may be removed:

1. Open the oven door fully (see diagram);

2. Lift up and turn the small levers located on the two hinges (see diagram);

Grip the door on the two external sides

and close it approximately half way.Pull

the door towards you lifting it out of its seat

(see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-

holder.

2. Remove the light bulb and replace it with

a similar one: Wattage 25 W, cap E 14.

3. Replace the glass cover (see diagram).

! Do not use the oven lamp as/for ambient

lighting.

Sliding Rack Kit assembly

To assemble the sliding racks:

1. Loosen the two screws A (see diagram).

If the oven is fitted with self-cleaning

panels, these will have to be temporarily

disassembled.

2. Replace the screws A with the screws and

spacers (B + C) supplied with the kit.

3. Tighten the new screws B and the

corresponding spacers C, tting the self-

cleaning panels on again.

4. Secure the two joints D of the guide rail in

the holes provided on the oven walls (see

diagram). The holes for the left guide rail

are situated at the top, while the holes for

the right one are at the bottom.

5. Finally, t the guide rail on the spacer C.

! Do not place the sliding racks in position 5.

Side and rear catalytic liners

These are panels coated with a special enamel, which is able to absorb the

fat released by food as it cooks.

This enamel is quite strong, so that the various accessories (racks, dripping

pans, etc.) can slide along them without damaging them. White marks may

appear on the surfaces; these are not a cause for concern.

Nevertheless, the following should be avoided:

- scraping the enamel with sharp objects (a knife, for example);

- using detergents or abrasive materials.

C B

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FH 83 C (BK)/HA S Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Indesit FH 83 C (BK)/HA S