AUS
9
! The position of the corresponding gas burner is
shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
• Off
Maximum
Minimum
To turn on one of the burners, place a lighted match or
lighter near the burner, press the knob all the way in and
turn it anti-clockwise to the "High" setting.
On those models fitted with a safety device, the knob
must be pressed in for about 6 seconds until the device
that keeps the flame lit warms up.
On those models fitted with an ignitor, the ignition button,
identified by the
symbol, must first be pressed and
then the corresponding knob pushed all the way in and
turned anti-clockwise to the "High" setting.
Some models are equipped with an ignition button
incorporated into the control knob. If this is the case, the
ignitor is present, but not the button.
To light a burner, simply press the corresponding knob all
the way in and then turn it anti-clockwise to the "High"
setting, keeping it pressed in until the burner lights.
Check that the gas has been lit. If the burner fails to
ignite try again. If the burner fails to ignite after 3
attempts, wait a few minutes for the gas to disperse
before making any further attempts.
If the burner still fails to ignite, a match or lighting
device can be used, but care must be taken. If the
problem persists, contact place of purchase or their
appointed agent for service.
If the flame has excessive yellowing, or appears to
lift off the burner ports, or makes a loud noise, turn
the burner off and call your service agent.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the “•” position).
Lighting the burners for the first time
If the appliance is being used for the first time, or if
it has not been used for a long period of time, it may
be necessary to purge the gas lines of excess air
before you can successfully light the burners.
To do this, turn each burner to High for 10-15
seconds and press the ignition button several times.
If the burner does not light, repeat this procedure
twice more. Wait 1-2 minutes for any gas build up to
disperse before allowing any further gas flow.
Practical advice on using the burners
To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see
table) so that the flames do not extend beyond the
bottom of the cookware.
• Always use cookware with a flat base and a
cover.
• When the contents of the pan reach boiling point,
turn the knob to minimum.
• Do not use pans which are unstable or which have
a warped or damaged base.
• Ensure the pot sits securely on the trivet and is
centred above the burner.
Burner ø Cookware diameter (cm)
Triple Crown (TC) 24 - 26
Semi Fast (S) 16 - 20
Auxiliary (A) 10 - 14
To identify the type of burner, refer to the designs in the
section entitled, "Technical Specifications".
Start-up and use
(72 Seiten)
(68 Seiten)
(28 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern