Indesit DVGN 623 IX Bedienungsanleitung PDF herunterladen (Seite 22)

Whenever the appliance fails to work, check for a solution from the following list before calling for Technical

Assistance Centre.

Troubleshooting

Malfunction: Possible causes / Solutions:

The dishwasher does not start.

 The plug has not been inserted into the electrical socket

properly, or there is no power in the house.

 The dishwasher door has not been shut properly.

 A delayed start has been programmed (see Start-up and use).

No water enters the

dishwasher.

 There is no water in the mains supply.

 The water inlet hose is bent (see Installation).

No water drains out from the

dishwasher.

 The dishwasher cycle has not yet finished.

 The water outlet hose is bent (see Installation).

 The drain duct is blocked.

 The filter is clogged up with food residues.

The dishwasher makes

excessive noise.

 The dishes are rattling against each other or against the

sprayer arms.

The dishes and glasses are

covered in a white film or

limescale deposits.

 The level of the refined salt is low or the dosage setting is not

suited to the hardness of the water (see Rinse aid and salt).

 The lid on the salt dispenser is not closed properly.

 The rinse aid has been used up or the dosage is too low.

 The crockery is made from non-stick material.

The dishes and glasses are

streaked or have a bluish

tinge.

 The rinse aid dosage is too high.

The crockery has not been

dried properly.

 The rinse aid has been used up or the dosage is too low (see

Rinse aid and salt).

 The rinse aid dispenser setting is not high enough.

 A wash cycle without a drying programme has been selected.

The dishes are not clean.

 The racks are overloaded (see Loading the racks).

 The crockery has not been arranged well.

 The sprayer arms cannot move freely.

 The wash cycle is too gentle (see Wash cycles).

 The detergent has not been measured out correctly or it is not

suited to the type of wash cycle (see Start-up and use).

 The filter is dirty or blocked (see Care and maintenance).

 The refined salt level is low (see Rinse aid and salt).

Shut off tap alarm.

(several short beeps are

emitted)*

* Only available in selected

models

(the 2

and 3

WASH CYCLE

indicator lights flash, beginning

from the right).

 Turn on the tap and the appliance will start after a few

minutes.

 The appliance lock has been activated because no action was

taken when the beeps* sounded. Switch off the machine using

the ON/OFF button, turn on the tap and switch the machine

back on after 20 seconds by pressing the same button. Re-

programme the machine and

restart the wash cycle.

Blocked filter alarm

(the

and 4th

WASH CYCLE

indicator lights flash beginning

from the right).

 Switch off the machine by pressing the ON/OFF button and

clean the filters (see Maintenance), then switch the

dishwasher back on by pressing the same button. Re-

programme the machine and restart the wash cycle.

Water loading solenoid valve

malfunction alarm

(the

WASH CYCLE indicator

lights flash beginning from the

right).

 Switch off the appliance by pressing the ON/OFF button and

switch it back on after a minute. If the alarm continues, turn

off the water tap to reduce the risk of flooding, remove the

plug from the electrical socket and call Assistance.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit DVGN 623 IX Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Indesit DVGN 623 IX