Indesit PBAA 34 NF D Bedienungsanleitung PDF herunterladen (Seite 22)

Troubleshooting

Malfunctions:

The display is completely switched off.

The motor does not start.

The display is on but it is dim.

The alarm sounds and DOOR OPEN

ALARM flashes on the display (d is

displayed instead of the

REFRIGERATOR temperature).

The alarm sounds and

TEMPERATURE ALARM flashes on

the display (A1 is displayed instead

of the FREEZER temperature).

The alarm sounds and temperature

alarm flashes on the display (A2 is

displayed instead of the FREEZER

temperature).

The refrigerator and the freezer do not

cool well.

The food inside the refrigerator is

beginning to freeze.

The motor runs continuously.

The appliance makes a lot of noise.

Early ending of functions

The freezer status bar LEDs do not

indicate the set temperature, and are

lit in a constant manner.

Possible causes / Solutions:

 The plug has not been inserted into the electrical socket, or not far enough to

make contact, or there is no power in the house.

 The appliance comes with a motor protection control (see Start-up and use).

 Pull out and reverse the plug before putting it back in the socket.



The refrigerator door has been open for more than two minutes.

The sound alert stops when the door is closed or when the appliance is

switched off and on again.

 The temperature inside the freezer is too high. The freezer will maintain a

temperature of around 0°C so that the food will not refreeze, allowing you to

eat it within 24 hours or to refreeze it after it has been cooked.

To switch off the buzzer, open and close the appliance door or press the +

and  freezer temperature adjustment buttons once. Press these buttons a

second time to display the set value on the freezer display, switch off the

TEMPERATURE ALARM LED and restore normal operation.

 The temperature of the freezer is dangerously high: the food inside must not

be eaten. The freezer will maintain a temperature of approximately -18°C.

To switch off the buzzer, open and close the appliance door or press the +

and  freezer temperature adjustment buttons once. Press these buttons a

second time to display the set value on the freezer display, switch off the

TEMPERATURE ALARM LED and restore normal operation.

 The doors do not close properly or the seals are damaged.

 The doors are opened too frequently.

 The temperature that has been set is too high (see Start-up and use).

 The refrigerator or the freezer have been over-filled.

 The temperature that has been set is too low (see Start-up and use).

 The SUPER COOL and/or SUPER FREEZE and/or BOTTLE CHILL functions

have been activated.

 The door is not closed properly or is continuously opened.

 The outside ambient temperature is very high.

 The appliance has not been installed on a level surface (see Installation).

 The appliance has been installed between cabinets that vibrate and make noise.

 The internal refrigerant makes a slight noise even when the compressor is off.

This is not a defect, it is normal.

 Electrical disturbance on the network or brief interruptions of the power supply.

 Contact the Technical Assistance Centre.

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the

following list.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit PBAA 34 NF D Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühl- und Gefrierschränke Indesit PBAA 34 NF D