Indesit 9YPS 645T (WH) GH/HA Bedienungsanleitung PDF herunterladen (Seite 11)

3. Reassemble the parts following the above procedure in the reverse

order.

4. Once this procedure is nished, replace the old rating sticker with

one indicating the new type of gas used. Sticker are available from

any of our Service Centres.



1. Remove the pan supports and lift the burners out of their housing.

The burner consists of two separate parts (see pictures).

2. Unscrew the nozzles using a 7 mm socket spanner. Replace the

nozzles with models that are congured for use with the new type of

gas (see Table 1). The two nozzles have the same hole diameter.

3. Replace all the components by completing the above operations in

reverse order.

• Adjusting the burners’ primary air

Does not require adjusting.

• Setting the burners to minimum

1. Turn the tap to the low ame position;

2. Remove the knob and adjust the

adjustment screw, which is positioned in or

next to the tap pin, until the ame is small

but steady.

3. Having adjusted the ame to the required low setting, while the burner

is alight, quickly change the position of the knob from minimum to

maximum and vice versa several times, checking that the ame does

not go out.

4. Some appliances have a safety device (thermocouple) tted. If the

device fails to work when the burners are set to the low ame setting,

increase this low ame setting using the adjusting screw.

5. Once the adjustment has been made, replace the seals on the by-

passes using sealing wax or a similar substance.

! If the appliance is connected to liquid gas, the regulation screw must

be fastened as tightly as possible.

! Once this procedure is nished, replace the old rating sticker with one

indicating the new type of gas used. Stickers are available from any of

our Service Centres.

! Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be tted

to the inlet pipe (in order to comply with current national regulations).

Electrical

connections

DATA PLATE

see data plate

This appliance conforms to the following

European Economic Community directives:

- 2006/95/EEC dated 12/12/06 (Low

Voltage) and subsequent amendments

- 2004/108/EEC dated 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments

- 93/68/EEC dated 22/07/93 and

subsequent amendments.

- 2009/142/EEC dated 30/11/09 (Gas) and

subsequent amendments.

- 2012/19/EC and subsequent

amendments.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit 9YPS 645T (WH) GH/HA Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Indesit 9YPS 645T (WH) GH/HA