Indesit IDCE 85 B TM (UK) Bedienungsanleitung PDF herunterladen (Seite 15)

Troubleshooting

Possible causes / Solutions:

• The plug has not been inserted far enough into the socket to make contact.

• There has been a power cut.

• The fuse has blown. Try connecting another appliance to the same socket.

• If an extension cord is used, try connecting the dryer plug directly into the socket.

• The door has not been closed properly.

• The programme has not been set correctly.

• The

START/PAUSE .

• A delayed start time has been set .

• The

START/PAUSE button has been pressed; a short delay follows before the dryer

starts running. Wait for the drying cycle to start; do not press the

START/PAUSE button

otherwise the dryer switches to the pause mode and the drying cycle will not start.

• The filter has not been cleaned .

• The water container must be emptied? The “Empty water container” indicator light

flashes and the message appears

“h2o” .

• The condenser needs to be cleaned .

• The heat setting is not suited to the type of fabric to be dried.

• An incorrect drying time was selected for the type of load .

• The items are too wet .

• The air intake grille are clogged up

• The dryer is overloaded .

• The water container was probably not emptied before starting the programme. Do

not wait for the signal for emptying the water container, but always check and empty

it before starting a new drying programme .

• It is normal: the “Empty water container” indicator light flashes when the water

container is full. If the indicator light is on but is not flashing, it is just a reminder to

empty the container

! For safety reasons, the dryer programmes last a maximum of 5 hours. If an automatic

programme has not detected the final dampness level required in this interval, the dryer

completes the programme and stops. Check the above points and repeat the programme;

if the items are still damp, contact the Technical Assistance Centre .

• If the display shows a fault, switch the appliance off and unplug it, then clean the filter

and the Heat Pump Filter unit . Reinsert the plug, switch the appliance

on and start another programme. If the display still visualises a fault, contact the

Technical Assistance Centre . If the display still visualises other numbers,

mark the code and contact the Technical Assistance Centre .

• The appliance is in “Demo” mode. Press the ON/OFF and

START/PAUSE buttons

and keep them pressed for 3 seconds. The display visualises

“dOn” for 3 seconds,

then the dryer starts functioning normally.

• The remaining time is constantly monitored during the drying cycle and is updated

to show the best forecast. It is normal for the displayed time to increase during the

cycle.

• This is normal, especially if the dryer has not been used for a long time. If the noise

persists during the entire cycle, contact the Technical Assistance Centre.

• The dryer has gone into standby mode to save power. This occurs if you have left

the dryer on or have had a power cut. It occurs after 30 minutes:

- if you leave the dryer without starting a programme;

- after your drying programme has finished.

Press the On/Off button and the lights will come on again.

If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical

Assistance Centre

Problem:

The dryer does not start.

The drying cycle does not start.

Drying times are too long.

The “Empty water container” indi-

cator light flashes, but the dryer has

been running for a short time.

The “Empty water container” indica-

tor light is on but the water container

is not full.

The programme is finished but the

items are damper than expected.

The code “F” appears on the display

followed by one or two numbers, the

options indicator lights and the pause

indicator light flash.

“dOn” briefly appears on the display

every 6 seconds.

The “Remaining time” indicator chan-

ges during the drying cycle.

The dryer is noisy during the first few

minutes of operation.

The lights on the dryer control panel

are off although the dryer is switched

on.

1 2 ... 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit IDCE 85 B TM (UK) Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wäschetrockner Indesit IDCE 85 B TM (UK)