Indesit FP M4.1 Bedienungsanleitung PDF herunterladen (Seite 13)

DATA PLATE

Dimensions

width cm 43.5

height cm 32

depth cm 41.5

Volume

lt. 58

Electrical

connections

voltage: 220-240V ~ 50/60Hz

maximum power absorbed 2800W

ENERGY LABEL

Directive 2002/40/EC on the label

of electric ovens.

Standard EN 50304

Energy consumption for Natural

convection – heating mode:

Convection mode.

Declared energy consumption for

Forced convection Class – heating

mode: Rotisserie.

This appliance conforms to the

following European Economic

Community directives:

-73/23/EEC of 19/02/73 (Low

Voltage) and subsequent

amendments;

- 89/336/EEC of 03/05/89

(Electromagnetic Compatibility) and

subsequent amendments;

- 93/68/EEC of 22/07/93 and

subsequent amendments.

- 2002/96/EC

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating current

at the voltage and frequency indicated on the data

plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal

board by inserting a

screwdriver into the side

tabs of the cover. Use

the screwdriver as a

lever by pushing it down

to open the cover

(see diagram).

2. Install the power

supply cable by

loosening the cable

clamp screw and the

three wire contact screws

L-N-

. Connect the

wires to the

corresponding terminals:

the Blue wire to the

terminal marked (N), the

Brown wire to the terminal marked (L) and the Yellow

Green wire

to the terminal marked (see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate (see side).

The appliance must be directly connected to the mains

using an omnipolar circuit-breaker with a minimum

contact opening of 3 mm installed between the appliance

and the mains, suitable for the load indicated and

complying with current electrical regulations (the earthing

wire must not be interrupted by the circuit-breaker). The

supply cable must not come into contact with surfaces

with temperatures higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

 The appliance is earthed and the plug is compliant

with the law.

 The socket can withstand the maximum power of

the appliance, which is indicated on the data plate

(see below).

 The voltage must be in the range between the

values indicated on the data plate (see below).

 The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should

these safety measures not be observed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FP M4.1 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit FP M4.1