Indesit FK 932 C X/HA Bedienungsanleitung PDF herunterladen (Seite 23)

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery,

and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

For more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small

levers

F F

F located on the two hinges (see diagram).

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you, lifting it

out of its slot (see diagram).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If

the seals are damaged, please contact your nearest

Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been

replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the

glass cover of the

lamp-holder.

2. Unscrew the

light bulb and

replace it with a

similar one:

Wattage 25 W,

cap E 14.

3. Replace the

glass cover (see

diagram).

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames,

lifting them away from the

spacers A (see figure).

2. Choose which shelf to use

with the sliding rack. Paying

attention to the direction in

which the sliding rack is to be

extracted, position joint B and

then joint C on the frame.

3. Secure the two frames with

the guide rails using the holes

provided on the oven walls

(see diagram). The holes for

the left frame are situated at

the top, while the holes for the

right frame are at the bottom.

4. Finally, fit the frames on the spacers A.

! Do not place the sliding racks in position 5.

Assistance

! Never use the services of an unauthorised technician.

Please have the following information to hand:

• The type of problem encountered.

• The appliance model (Mod.).

• The serial number (S/N).

The latter two pieces of information can be found on

the data plate located on the appliance.

Care and maintenance

Guida

sinistra

Guida

destra

Verso di

estrazione

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FK 932 C X/HA Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit FK 932 C X/HA