Indesit FK 939J X/HA S Bedienungsanleitung PDF herunterladen (Seite 23)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers F located on the two

hinges (see diagram).

3. Grip the door on the two outer sides and

close it approximately half way. Pull the

door towards you, lifting it out of its slot (see

diagram). To replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the

lamp-holder.

2. Remove the light bulb and replace

it with a similar one: Wattage 25 W,

cap E 14.

3. Replace the glass cover (see

diagram).

! Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames, lifting

them away from the spacers A (see

gure).

2. Choose which shelf to use with the

sliding rack. Paying attention to the

direction in which the sliding rack is

to be extracted, position joint B and

then joint C on the frame.

3. Secure the two frames with the

guide rails using the holes provided

on the oven walls (see diagram).

The holes for the left frame are

situated at the top, while the holes

for the right frame are at the bottom.

4. Finally, fit the frames on the

spacers A.

! Do not place the sliding racks in position 5.

Left

guide rail

Right guide

rail

Direction

of extraction

* Only available in certain models.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FK 939J X/HA S Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Indesit FK 939J X/HA S