Indesit IDL 55T49 EU.2 Bedienungsanleitung PDF herunterladen (Seite 14)

Connecting the water outlet hose

Connect the outlet hose (without bending it) to a drain

duct with a minimum diameter of 4 cm. Alternatively,

rest it over a sink or tub; the free end of the hose

should not remain immersed in water.

The special plastic elbow*

makes it easier to find the

best layout: fix the elbow

to the wall securely in

order to prevent the outlet

hose from moving and

spilling the dirty water.

The part of the hose

marked with the letter A

should be between 40

and 100 cm above the ground (

see figure

 We advise against the use of hose extensions.

Electrical connection

Before inserting the plug into the electrical socket,

make sure that:

• the socket is earthed and complies with current

regulations;

• the socket can withstand the maximum load of the

appliance, which is indicated on the data plate

located on the inside of the door (

see Description

of the appliance

);

• the power supply voltage falls within the values

indicated on the data plate on the inside of the

door;

• the socket is compatible with the plug of the

appliance. If this is not the case, ask an authorised

technician to replace the plug (

see Assistance

); do

not use extension cables or multiple sockets.

 Once the appliance has been installed, the power

supply cable and the electrical socket should be

easily accessible.

 The cable should not be bent or compressed.

 The cable should be checked regularly and replaced

by authorised technicians only (

see Assistance

 The Company shall not be held responsible for any

incidents that occur if these regulations are not

observed.

Advice regarding the first wash cycle

After the appliance has been installed, immediately

before running the first wash cycle, completely fill the

salt dispenser with water and add approximately 2 kg

of salt (

see Rinse aid and refined salt

). The water may

overflow: this is normal and is not a cause for concern.

It is also normal that the LOW SALT* indicator light

continues to flash for a few cycles after the salt has

been loaded.

* Only available in selected models.

Dimensions

width 60 cm

height 85 cm

depth 60 cm

Capacity

12 standard place-settings

Water supply

pressure

30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)

4.3 psi – 145 psi

Power supply

voltage

See appliance data plate

Total absorbed

power

See appliance data plate

Fuse

See appliance data plate

This dishwasher conforms to

the following European

Community Directives:

-73/23/EEC dated 19/02/73

(Low Voltage) and subsequent

modifications

-89/336/EEC dated 03/05/89

(Electromagnetic Compatibility)

and subsequent modifications

-97/17/EC (Labelling)

-2002/96/ CE

Waste

Electrical and Electronic

Equipment (WEEE)

Technical data

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit IDL 55T49 EU.2 Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Indesit IDL 55T49 EU.2