Indesit KP9F96S(X)/AUS Bedienungsanleitung PDF herunterladen (Seite 8)

AUS

Start-up and use

Hob operation

The burners are fitted with automatic ignition and a

thermocouple safety device, which automatically cuts

off the gas from the burner in a few seconds if the

flame accidentally goes out during operation.

The burners differ in size and power. Choose the most

appropriate one for the diameter of the cookware

being used.

Each burner can be regulated with the corresonding

control knob by using one of the following settings:

Off n

High flame

Low flame

The symbols near the knobs show the position of

the relative burner on the hob.

To ignite a burner, proceed as follows:

 turn the relative knob counter-clockwise until the

pointer is on the high-flame symbol;

 press the knob down fully and activate the

automatic gas ignition by pushing at the same time

the button marked with the symbol

;

 keep the knob pressed down for about 10 seconds

with the flame lit to allow the safety thermocouple to

be heated;

 release the knob, checking that the flame is stable.

If it is not, repeat the operation.

Check that the gas has been lit. If the burner fails to

ignite try again. If the burner fails to ignite after 3

attempts, wait a few minutes for the gas to disperse

before making any further attempts.

If the burner still fails to ignite, a match or lighting

device can be used, but care must be taken. If the

problem persists, contact place of purchase or their

appointed agent for service.

If the flame has excessive yellowing, or appears to

lift off the burner ports, or makes a loud noise, turn

the burner off and call your service agent.

For minimum power, turn the knob towards the low

flame symbol. Intermediate positions are possible

by simply putting the knob anywhere between the

high and the low flame symbol.

To turn off the burner, turn the knob clockwise to the

off position "

" .

Important:

 Do not activate the automatic ignition device for

more than 15 consecutive seconds.

 Difficulty in ignition is sometimes due to air inside

the gas duct.

 If a burner flame accidentally goes out, the gas

continues to exit for a few moments before the

safety device activates. Turn the control knob to the

off position and do not attempt ignition again for at

least 1 minute, thereby letting the gas disperse,

which could otherwise be a danger.

 When the appliance is not in operation, check that

the knobs are in the off position "

" . The main gas

supply cut-off cock should also be closed.

Lighting the burners for the first time

If the appliance is being used for the first time, or if

it has not been used for a long period of time, it may

be necessary to purge the gas lines of excess air

before you can successfully light the burners.

To do this, turn each burner to High for 10-15

seconds and press the ignition button several times.

If the burner does not light, repeat this procedure

twice more. Wait 1-2 minutes for any gas build up to

disperse before allowing any further gas flow.

Using the burners:

To obtain maximum efficiency from the burners, it is

advisable to only use pans with a diameter suitable for

the burner being used, so that the flame does not

extend beyond the pan base (see following table).

When a liquid starts boiling, it is advisable to turn the

flame down just enough to keep the liquid

simmering.

Burner ø Cookware Diameter (cm)

Fast (R) 24 - 26

Semi Fast (S) 16 - 20

Auxiliary (A) 10 - 14

Triple Crown (TC) 24 - 26

Always use cookware with a flat base. Do not use

pans which are unstable or which have a warped or

damaged base.

Ensure the pot sits securely on the trivet and is

centred above the burner.

The hob is fitted with reducing pan stands, which

should only be used on auxiliary burner "A".

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit KP9F96S(X)/AUS Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Küchen- und Haushaltswarenzubehör Indesit KP9F96S(X)/AUS