Indesit KP9F96S(X)/AUS Bedienungsanleitung PDF herunterladen (Seite 3)

AUS

(b) Through to an outside wall but offset.

(d) Into an underfloor space ventilated to outside.

(e) Into a roof space ventilated to outside.

NOTE 2 The two openings may be combined

provided that the top and bottom of the opening

reach the limits set by this Clause.

Natural ventilation via adjacent room

Two permanent openings shall be provided in the

room or enclosure. The openings shall be located to

ensure the distance between the top of the upper

opening and the ceiling of the room or enclosure,

and the distance between the bottom of the lower

opening and the floor of the room or enclosure does

not exceed 5% of the height of the room or

enclosure.

The minimum free ventilation area provided by each

opening shall be calculated using the following

formula:

A = 6 × T

where

A = the minimum free ventilation area (cm

)

T = the total gas consumption of all appliances

(MJ/h)

These requirements shall apply to all subsequent

rooms until a room is ventilated to outside, in

accordance with the previous section, or the total

input of the appliances does not exceed 3 MJ/h for

each cubic metre of the total volume of the

enclosure and rooms.

The minimum vertical dimension of any free

ventilation opening shall be 6 mm.

NOTE: The two openings may be combined

provided that the top and bottom of the opening

reach the limits set by this Clause.

If an electric fan is used for extracting the

combustion products, the ventilation aperture must

be increased in relation to its maximum

performance. The electric fan should have a

sufficient capacity to guarantee an hourly exchange

of air equal to 3 ÷ 5 times the volume of the kitchen.

Prolonged, intensive use of the appliance may

require extra ventilation, e.g. an open window or a

more efficient ventilation system by increasing the

extraction power of the electric fan if installed. Liquid

petroleum gas descends towards the floor as it is

heavier than air. Apertures in the outside walls in

rooms containing LPG cylinders should therefore be

at floor level, in order to allow any gas from leaks to

be expelled. Do not store LPG cylinders (even when

empty) in basements or rooms below ground level; it

is advisable to keep only the cylinder in use in the

room at any one time and connected far from heat

sources which could raise its temperature to above

50 °C.

Range hoods

Range hoods and overhead exhaust fans must be

installed according to manufacturers instructions

but in no case shall clearance from hob burners be

less than 600 mm for range hoods and 750 mm for

overhead exhaust fans.

If the hood is installed below a wall cabinet, the

latter must be at least 700 mm (millimetres) above

the surface of the hob.

Safety Chain

In order to prevent

accidental tipping of

the appliance, for

example by a child

climbing onto the open

oven door, the supplied

safety chain must be

installed.

Ensure the chain is

secured to the rear wall

of the oven, and attach

the chain to a hook or screw secured to the wall

behind the appliance.

NOTE: If the cooker is placed on a base, measures

must be taken to prevent the appliance slipping

from the base.

This appliance is suitable for use with either a

flexible connection or rigid copper connection.

Check The Gas Type

 Before installation, check that the gas type (natural

gas or LPG/Propane) of the cooker is suitable for the

gas type available to the installation. It is extremely

dangerous to use the wrong gas type with any

appliance, as fire or serious injury can result.

This cooker is supplied from the factory already set

for Natural Gas. To convert the cooker to LPG (or

back to Natural Gas from LPG), follow the directions

later in this section.

Fit regulator supplied for Natural Gas (if applicable)

at rear of appliance, and as close as practicable to

the appliance.

It is recommended that an isolating valve and union

be fitted, to enable simple disconnection for

servicing. These are to be in an accessible location.

Either a rigid metal pipe

with fittings in

compliance with the

standards in force must

be used for connecting

to the nipple union

(threaded ½G male

fitting) situated at the

rear of the appliance to

the right, or an

1 2 3 4 5 6 7 8 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit KP9F96S(X)/AUS Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Küchen- und Haushaltswarenzubehör Indesit KP9F96S(X)/AUS