CONTROL PANEL
FIRST TIME USE
POWER MANAGEMENT
Thanks to the “Power management” function, the user can set the
maximum power the hob can reach, as required.
This setting is possible at any time and is maintained until the next change.
By setting the required maximum power, the hob automatically adjusts
distribution in the various cooking zones, ensuring that this limit is never
exceeded; with the advantage of also being able to manage all the zones
simultaneously, but without overload problems.
4 maximum power levels are available and showed on display: 2.5kW –
4.0kW – 6.0kW – 7.2kW (7.2 kW is considered as max. power of cooktop).
At the time of purchase, the hob is set to maximum power.
To set the hob power:
After plugging the appliance into the electrical socket, in the rst 60 seconds
it is possible to set the required power level by running the following points:
• Press for approximately 3 seconds button . The display shows .
• Press the Power Management button to conrm the previous step.
The display shows .
• Press buttons / to select the required power. The display
shows the power levels available.
• Press the Power Management button to conrm the previous
step. The display shows the set level which ashes for approximately
2 seconds; after which the hob emits an acoustic signal and then
turns itself o; it is now ready for use.
In case of an error when setting the power, the symbol appears in
the middle and an acoustic signal sounds for about 5 seconds. In this
case repeat the conguration procedure from the beginning. If the error
occurs again, contact the After-Sales Service.
During normal use, if the user tries to increase the maximum available
power level when reached, the level of the zone in use ashes twice and
an acoustic signal sounds.
To obtain a higher power in that zone, it is necessary to manually
decrease the power level of one or more already active cooking zones.
ACCESSORIES
POTS AND PANS
Only use pots and pans made from ferromagnetic
material which are suitable for use with induction hobs.
To determine whether a pot is suitable, check for the
symbol (usually stamped on the bottom). A magnet
may be used to check whether pots are magnetic. The
quality and the structure of the pot base can alter cooking performance.
RECOMMENDED POT BOTTOM WIDTHS
Place the pot on the required cooking zone before switching the hob on.
For good cooking results, the diameter of the base of the pot should
match the size of the hotplate.
IMPORTANT: The cooking zones will not switch on if pots are not the right size.
To determine the size of the pot please measure the base of the pot and refer
to recommended pots bottom width table, for perfect usage and correct pan
detection. Each cooking zone has a minimum limit of detecting pans, which
varies depending on the material of the pan being used. You should therefore
use the cooking zone that is most suitable for the diameter of your pan.
DIAMETER cm MAX cm MINcm
14,5 14,5 10
18 18 12
21 21 15
RECOMMENDED POT POSITION
For best performance, when you use two pots simultaneously, put them
according to the pictures below:
IMPORTANT: To avoid a permanent damage the hob:
• do not use pots with bottoms that are not at;
• do not use metal pots with enamelled bottom;
• do not place hot pots/pans over the control panel.
On / O Timer Control panel lock /
Power management
Cooking zone controls and corresponding display
EN
(32 Seiten)
(32 Seiten)
(80 Seiten)
(16 Seiten)
(32 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern