Indesit I5GG(X)/U Bedienungsanleitung PDF herunterladen (Seite 6)

Connecting a flexible jointless stainless steel pipe to

a threaded attachment

Make sure that the hose and gaskets comply with

current national legislation.

To begin using the hose, remove the hose holder on the

appliance (the gas supply inlet on the appliance is a

cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose

length does not exceed a maximum of 2 metres,

making sure that the hose is not compressed and does

not come into contact with moving parts.

Checking the connection for leaks

When the installation process is complete, check the

hose fittings for leaks using a soapy solution. Never

use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas

other than the default type (this is indicated on the

rating label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:

1. Remove the hob grids and slide the burners off their

seats.

2. Unscrew the nozzles using a 7 mm socket spanner

(see  gure), and replace them with nozzles suited to

the new type of gas(see Burner and nozzle speci cations

table).

3. Replace all the components by following the above

instructions in reverse.

Adjusting the hob burners’

minimum setting:

1. Turn the tap to the minimum

position.

2. Remove the knob and adjust

the regulatory screw, which is

positioned inside or next to the tap pin, until the flame

is small but steady.

! If the appliance is connected to a liquid gas supply,

the regulatory screw must be fastened as tightly as

possible.

3. While the burner is alight, quickly change the position of

the knob from minimum to maximum and vice versa several

times, checking that the flame is not extinguished.

! The hob burners do not require primary air

adjustment.

Adapting the oven

Replacing the oven burner nozzle:

1. Remove the oven compartment.

2. Slide out the protection panel A

(see diagram).

3. Remove the oven burner

after unscrewing the screws V

(see  gure).

The whole operation will be

made easier if the oven door is

removed.

4. Unscrew the nozzle using a

special nozzle socket spanner

(see  gure) or with a 7 mm

socket spanner, and replace it

with a new nozzle that is suited

to the new type of gas (see

Burner and nozzle speci cations

table).

Adjusting the gas oven

burner’s minimum setting:

1. Light the burner (see Start-up

and Use).

2. Turn the knob to the

minimum position (MIN) after it has been in the

maximum position (MAX) for approximately 10 minutes.

3. Remove the knob.

4. Tighten or loosen the adjustment screws on the

outside of the thermostat pin (see  gure) until the flame

is small but steady.

! If the appliance is connected to liquid gas, the

adjustment screw must be fastened as tightly as

possible.

5. Turn the knob from the MAX position to the MIN

position quickly or open and shut the oven door,

making sure that the burner is not extinguished.

1 2 3 4 5 6 7 8 9 10 11 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit I5GG(X)/U Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Indesit I5GG(X)/U