Indesit 7OHH 627 IXRU/HA Bedienungsanleitung PDF herunterladen (Seite 11)

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external parts as

well as the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water and

neutral soap. If these stains are difficult to remove,

use only specialised products. After cleaning, rinse

and dry thoroughly. Do not use abrasive powders or

corrosive substances.

• Ideally, the inside of the oven should be cleaned after

each use, when it is still lukewarm. Use hot water and

detergent, rinse and dry with a soft cloth. Do not use

abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery, and

are even dishwasher safe.

! Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could scratch

the surface and cause the glass to crack.

To clean more thoroughly, you

can remove the oven door.

1. Open the oven door fully

(

see diagram

2. Use a screwdriver to lift up

and turn the small levers

located on the two hinges (

see

diagram

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps

F, then pull the door

towards you lifting it out of its

seat (

see diagram

).*

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you lifting it

out of its seat (

see diagram

).*

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (

see Assistance

). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of

the lamp-holder.

2. Remove the light bulb and

replace it with a similar one:

Wattage 25 W, cap E 14.

3. Replace the glass cover (

see

diagram

Sliding Rack Kit assembly

To assemble the sliding racks:

1. Loosen the two screws A

(

see diagram

). If the oven is

fitted with self-cleaning panels,

these will have to be temporarily

disassembled.

2. Replace the screws A with the

screws and spacers (B + C) supplied

with the kit.

3. Tighten the new screws B and the

corresponding spacers C, fitting the

self-cleaning panels on again.

4. Secure the two joints D of the

guide rail in the holes provided

on the oven walls (

see diagram

The holes for the left guide rail

are situated at the top, while the

holes for the right one are at the

bottom.

5. Finally, fit the guide rail on the spacer C.

! Do not place the sliding racks in position 5.

Only on certain models

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit 7OHH 627 IXRU/HA Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Indesit 7OHH 627 IXRU/HA