Indesit KD643E Bedienungsanleitung PDF herunterladen (Seite 28)

Warning - THIS APPLIANCE MUST BE EARTHED

The cooker must be connected by a qualified electrician to a suitable double - pole control unit

with a minimum rating of 32A and a minimum contact clearance of 3mm, which should be

fitted adjacent to (but not above) the cooker, in accordance with IEE regulations.

The power supply cable should conform to BS6004 with a conductor size of 4mm

The control unit should be easily accessible in the event of an emergency.

This appliance conforms to EN55014 regarding suppression of radio and television interference.

Access to the mains terminals is gained by removing the rear access cover.

The mains cable must pass through the cable clamp adjacent to the terminal block, and the

screws must be fully tightened. Sufficient cable should be used to allow the cooker to be pulled

out for servicing.

Take care not to trap the mains cable when pushing the cooker into its final position.

After installation, check for gas soundness.The supply pressure can be checked at one of the

hotplate burner injectors.

Check that the hotplate burners ignite correctly and burn with a steady flame.Check for a steady

flame at the low setting.

Instruct the user on the operation of the cooker.

Electrical Installation

Operational Checks

1 2 ... 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Indesit KD643E Bedienungsanleitung Seite 28