Indesit FM 10 RK.C GB Bedienungsanleitung PDF herunterladen (Seite 11)

Instalation

The appliance must be installed only by a qualified

person in compliance with the instructions provided.

The manufacturer declines all responsibility for improper

installation which may harm persons and animals and

damage property.

Blocco Vuoto

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop-

erly, the cabinet containing it must be appropriate. The

figure below gives the dimensions of the cut-out for instal-

lation under the counter or in a wall cabinet unit.

In order to ensure adequate ventilation, the back panel of

the cabinet unit must be removed. Installing the oven so

that it rests on two strips of wood is preferable. If the oven

rests on a continuous, flat surface, there must be an ap-

erture of at least 45 x 560 mm.

The panels of the adjacent cabinets must be made of heat-

resistant material. In particular, cabinets with a veneer ex-

terior must be assembled with glues which can withstand

temperatures of up to 100 °C.

In compliance with current safety standards, contact with

the electrical parts of the oven must not be possible once

it has been installed.

All parts which ensure the safe operation of the appliance

must be removable only with the aid of a tool.

To fasten the oven to the cabinet, open the door of the

oven and attach it by inserting the 4 wooden screws into

the 4 holes located on the perimeter of the frame.

Electrical connection

Ovens with a three-pole power supply cable are designed

to operate with alternated current at the supply frequency

and voltage indicated on the data plate (at the bottom of

the oven dashboard). The earthing conductor of the cable

is the yellow-green conductor.

Two types of connection are provided:

Connection n° 1

Connecting the power supply cable to the mains.

Fit a normalized plug to the cable, which corresponds to

the load indicated on the data plate; if the cooker is

connected directly to the mains, an omnipolar circuit-

breaker with a minimum opening of 3 mm between the

contacts, suitable for the load indicated and complying

with current directives, must be installed between the

appliance and the mains (the earthing wire must not be

interrupted by the circuit-breaker). The power supply cable

must be positioned so that it does not exceed room tem-

perature by 50°C at any point of its length. Before making

the connection check that:

• the circuit breakers or fuses of the home system can

support appliance load (see data plate);

• the power supply system has an efficient earthing

connection which complies with the provisions of

current regulations and the law;

• there is easy access to the socket or the omnipolar

circuit-breaker once the cooker has been installed.

N.B.: do not use reducers, adapters or shunts as these

could cause heating or burning.

Connection n° 2

Disposing of the plug.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Ensure that before disposing of the plug itself, you make

the pins unusable so that it cannot be accidentally inserted

into a socket. Instructions for connecting cable to an alter-

native plug:

595 mm.

24 mm.

545 mm.

5 mm.

567 mm.

23 mm.

593 mm.

45 mm.

558 mm.

N.B.: Installation in compliance with the consumption declaration

595 mm.

24 mm.

545 mm.

5 mm.

567 mm.

23 mm.

575-585 mm.

558 mm.

595 mm.

45 mm.

min.

45 mm.

min.

560 mm.

45 mm.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit FM 10 RK.C GB Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ofen Indesit FM 10 RK.C GB