Indesit P 604 GB Bedienungsanleitung PDF herunterladen (Seite 6)

Installation Instructions for built-in

The following instructions are directed at the qualified

installer so that the installation and maintenance

proceedures may be followed in the most professional and

expert manner possible.

Important: Unplug the electrical connection before

performing any maintenance or regulation upkeep

work.

Installation of built-in stove tops

The electric hobs are prepared with protection degree

against excessive heating of Y type, it is therefore possible

to instal them next to furniture which is higher than the

working board. For a correct installation of the cooking

top the following precautions must be followed:

a) The hob may be located in a kitchen, a kitonen/diner

or bed sitting room, but no in a bathroom or shower

room.

b) The hoods must be installed according to the

requirements in the hood handbook.

c) The dimensions of the cutout for the appliance must

be those indicated in the figure. Clamps are provided

to fasten the cooktop to counters measuring from 20

to 40 mm in thickness. To fasten the cooktop securely,

it is recommended that all the clamps be used.

555 mm.

55 mm.

475 mm.

Fastening Clamps - Assembly Diagram

Clamp Position for Clamp Position for

H=20mm top H=30mm top

Front

Clamp Position for

H=40mm top Back

N.B: Use the clamps contained in the "accessory kit."

d) In case a wooden panel should be fitted under the top

for insulation, it will have be fitted at a minimum distance

of 20 mm from the inferior part of the top.

Important: When installing the hob on a built-in oven, the

oven should be placed on two wooden strips; in the case

of a joining cabinet surface, remember to leave a space

of at least 45 x 560 mm at the back.

560 mm.

45 mm.

When installing on a built-in oven without forced ventilation,

ensure that there are air inlets and outlets for ventilating

the interior of the cabinet adequately. Assembly examples

are given in figs.

Electrical connection for electric hob

The following installation procedure must be carried out

by a qualified electrician.

Important: the cooker must be connected to the mains

by a switched (double pole) cooker outlet correctly fused

with a capacity appropriate to that shown on the hob Rating

Plate. All electrical wiring from the consumer unit to the

appliance, via the switched double pole cooker outlet, must

be of an acceptable type and current rating as above. The

supply cord, type H05 VV-F 3x2.5mm

, must be positioned

so that it never reaches at any point a temperature 50°C

higher than the room temperature. The electrical

installation must comply with the IEE Regulations, Building

Regulation & local By-Lays.

WARNING: THIS APPLIANCE MUST BE EARTHED.

In the case of installation over a built-in electric oven the

electrical hook-up of the stove top and that of the oven

should be separate, for reasons of safety as well as for

ease of eventual removal of the oven.

Supply cable installation

The electrcic hobs are supplied without cable. Use a cable:

H05 VV-F 3x2.5mm

• Open the terminal box by removing the "V" screw and

taking off the cover.

• The wires in the mains lead are coloured in accordance

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit P 604 GB Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Indesit P 604 GB