Indesit I6M6C6AG(W)-FR Bedienungsanleitung PDF herunterladen (Seite 20)

between two cupboards), the flexible steel hose must

be used instead (see below).

Connecting a flexible jointless stainless steel pipe to

a threaded attachment

Make sure that the hose and gaskets comply with current

national legislation.

To begin using the hose, remove the hose holder on the

appliance (the gas supply inlet on the appliance is a

cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose

length does not exceed a maximum of 2 metres, making

sure that the hose is not compressed and does not come

into contact with moving parts.

Checking the tightness of the connection

When the installation process is complete, check the

hose fittings for leaks using a soapy solution. Never use

a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas

other than the default type (this

is indicated on the rating label on

the cover).

Adapting the hob

Replacing the nozzles for the hob

burners:

1. Remove the hob grids and

slide the burners off their seats.

2. Unscrew the nozzles using a 7 mm socket spanner

(see  gure), and replace them with nozzles suited to the

new type of gas (see Burner and nozzle speci cations table).

3. Replace all the components by following the above

instructions in reverse.

Adjusting the hob burners’ minimum setting:

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory screw,

which is positioned inside or next to the tap pin, until the

flame is small but steady.

! If the appliance is connected to a liquid gas supply, the

regulatory screw must be fastened as tightly as possible.

3. While the burner is alight, quickly change the position of the

knob from minimum to maximum and vice versa several times,

checking that the flame is not extinguished.

! The hob burners do not require primary air adjustment.

Safety Chain

! In order to prevent accidental tipping of the appliance, for

example by a child climbing onto the oven door, the supplied

safety chain MUST be installed!

The cooker is ﬁ tted with a safety chain to be ﬁ xed by means

of a screw (not supplied with the cooker) to the wall behind

the appliance, at the same height as the chain is attached

to the appliance.

Choose the screw and the screw anchor according to the

type of material of the wall behind the appliance. If the head

of the screw has a diameter smaller than 9mm, a washer

should be used. Concrete wall requires the screw of at least

8mm of diameter, and 60mm of length.

Ensure that the chain is ﬁ xed to the rear wall of the cooker

and to the wall, as shown in ﬁ gure, so that after installation

It is tensioned and parallel to the ground level.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit I6M6C6AG(W)-FR Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Indesit I6M6C6AG(W)-FR