Indesit IP641SCANUK Bedienungsanleitung PDF herunterladen (Seite 3)

Front

Hooking position Back

for top H=40 mm

 Use the hooks contained in the accessory pack

 Where the hob is not installed over a built-in oven, a

wooden panel must be installed as insulation. This

must be placed at a minimum distance of 20 mm from

the lower part of the hob.

Ventilation

To ensure adequate ventilation, the back panel of the

cabinet must be removed. It is advisable to install the

oven so that it rests on two strips of wood, or on a

completely flat surface with an opening of at least 45 x

560 mm (see diagrams).

! The hob can only be installed above built-in ovens with a

cooling ventilation system.

Electrical connection

The cooktops fitted with a tripolar electrical supply

cord are designed to be be used with alternating

current according to the indications on the rating

plate located under the cooktop. The earthing wire

can be identified by its yellow-green colour.

In the case of installation over a built-in electric

oven, the electrical connections for the cooktop and

oven should be independent, not only for safety

purposes, but also to facilitate removal of one or

both in the future.

Electrical Connection for Gas Cooktop

Fit the supply cord with a standard plug for the

demand rate indicated on the rating plate or connect

it directly to the electrical mains. In the latter case, a

single pole switch must be placed between the

appliance and the mains, with a minimum opening

between the contacts of 3 mm in compliance with

current safety codes (the earthing wire must not be

interrupted by the switch). The power supply cord

must be positioned so that it does not reach a

temperature in excess of 50°C above room

temperature at any point.

 The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before making the actual connection, make sure

that:

 The fuse and electrical system can withstand the

load required by the appliance;

 That the electrical supply system is equiped with

an efficient earth hook-up according to the norms

and regulations prescribed by law;

 That the plug or switch is easily accessible.

 The wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the wires in the mains lead may

not correspond with the coloured markings

identifying the terminals in your plug, proceed as

follows:

Connect the Green & Yellow wire to the terminal

marked E or

or coloured Green or Green &

Yellow.

Connect the Brown wire to the terminal marked L or

coloured Red.

Connect the Blue wire to the terminal marked N or

coloured Black.

 The cable must not be bent or compressed.

 The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

 The manufacturer declines any liability should

these safety measures not be observed.

Gas connection

The appliance should be connected to the main gas supply

or to a gas cylinder in compliance with current national

regulations. Before carrying out the connection, make sure

the cooker is compatible with the gas supply you wish to

560 m

45 m

1 2 3 4 5 6 7 8 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit IP641SCANUK Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Küche Indesit IP641SCANUK