Indesit CP 059 MD (X) AUS S Bedienungsanleitung Seite 9

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 8
AUS
9
Start-up and use
Using the hob
Lighting the burners
For each BURNER knob there is a complete ring showing the strength of the
ame for the relevant burner.
To light one of the burners on the hob:
1. Bring a ame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an anticlockwise direction so that it
is pointing to the maximum ame setting .
3. Adjust the intensity of the ame to the desired level by turning the BURNER
knob in an anticlockwise direction. This may be the minimum setting , the
maximum setting or any position in between the two.
If the appliance is tted with an electronic
lighting device* (see figure), press the
BURNER knob and turn it in an anticlockwise
direction, towards the minimum ame setting,
until the burner is lit. The burner might be
extinguished when the knob is released. If this
occurs, repeat the process, holding the knob
down for a longer period of time.
! If the ame is accidentally extinguished, switch off the burner and wait for
at least 1 minute before attempting to relight it.
If the appliance is equipped with a ame failure safety device*, press and
hold the BURNER knob for approximately 2-3 seconds to keep the ame
alight and to activate the device.
To switch the burner off, turn the knob until it reaches the stop position .
The “separate double ame” burner*
This burner consists of two concentric burners which can operate either
together or separately.
Use of the double ame on the maximum setting gives a very high power
which reduces cooking times with respect to conventional burners.
Moreover the double ame crown provides a more uniform distribution of heat
on the bottom of the pan, when using both burners on minimum.
To ensure that the double-ame burner is used to its full potential,
never set the inside ring to minimum and the outside ring to maximum
at the same time.
Pots and pans of all sizes can be used. In the case of the smaller pots and
pans we recommend the use of only the internal burner.
There is a separate control knob for each of the “separate double ame”
burners.
The knob marked by the symbol operates the external burner;
The knob marked by the symbol operates the internal burner.
To turn on one of the rings, press the relative knob in all the way and turn it
anti-clockwise to the high setting .
The burner is tted with an electronic igniter that automatically starts when
the knob is pressed in.
Since the burner is equipped with a safety device, after lighting the burner
keep the knob pressed in for about 2-3 seconds to allow the device which
keeps the ame lit automatically to heat up.
The selected burner can be regulated using the corresponding knob, as
follows:
Off
Maximum
Minimum
To switch off the burner, turn the knob in a clockwise direction until it stops
(when reaches the “” position).
Practical advice on using the burners
For the burners to work in the most efcient way possible and to save on the
amount of gas consumed, it is recommended that only pans which have a lid
and a at base are used. They should also be suited to the size of the burner.
Rapid (R)
Semi Rapid (S)
Auxiliary (A)
Triple Crown (TC)
Double Flame (DCDR internal)
Double Flame (DCDR external)
24 - 26
16 - 20
10 - 14
24 - 26
10 - 14
26 - 28
Burner Ø Cookware diameter (cm)
The hob is tted with reducing pan stands, which should only be used on
auxiliary burner “A” and on the DC-DR (inner) “B”.
A B
For the best performance of your burners, keep the following in mind: All
types of pans can be used on the burners. The important thing is that the
bottom should be completely even.
WARNING! The glass lid can break in if it
is heated up. Turn off all the burners and
the electric plates before closing the lid.
Applies to the models with glass cover only.
Using the oven
WARNING ! The oven is provided
with a stop system to extract the
racks and prevent them from coming
out of the oven (1).
As shown in the drawing, to extract
them completely, simply lift the racks,
holding them on the front part, and
pull (2).
* Only available in certain models.
Seitenansicht 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare