Indesit PPF Q40DCDR Bedienungsanleitung PDF herunterladen (Seite 16)

Securing the appliance to the cabinetSecuring the appliance to the cabinet

Securing the appliance to the cabinet

There are three different groups of appliance as far as

installation is concerned:

1- Built-in hobs to be slotted in (Class 3 - see figure 2,

detail H1). In this case it is necessary to make a

hole in the worktop whose measurements match

those of the hob. The measurement at the side

should be reduced by 1 cm so as to ensure that 1

cm of the perimeter of the hob overlaps with and

rests on top of the supporting surface. To slot in the

hob flush with the worktop, the cut-out on this

supporting surface must be lowered (see figure 4a),

so that both the edge of the hob and the seal under

it can be positioned there. Before fitting the hob to

the worktop, position the seal provided along the

perimeter of the hob, as illustrated in figure 4b.

Brackets for fixing hobs to the cabinet have been

provided, and these should be fitted as shown in

detail S (fig.3).

BUILT-IN HOB

HEIGHT= STEEL THICKNESS

BUILT-IN HOB

STEEL TICKNESS <HEIGHT <58mm

SIT ON - ON HOB

HEIGHT >58mm

Fig.2

Fig.3

2- Built-in hobs (Class 3) with edges lower than 58 mm

(see figure 2, detail H2). To install this type of hob, a

hole large enough to accommodate the whole lower

casing of the appliance must be made on the

worktop intended to be under the hob. Remember to

leave a gap of at least 1 cm between the lower

casing and the worktop around the whole perimeter

of the appliance (the underside of the casing can,

however, touch the surface below it). To fit the

appliances, follow the instructions given above in

point 1 or use any supplementary instruction leaflet

that is provided in special cases.

Fig.1

700mm

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Keine Kommentare

Indesit PPF Q40DCDR Bedienungsanleitung Seite 16