AUS
5
! Should the gas pressure used
be different (or vary slightly) from the recommended
pressure, a suitable pressure regulator must be
fitted to the inlet hose in accordance with current
national regulations relating to “regulators for
channelled gas”.
Adapting the oven
Replacing the oven burner nozzle:
1. Remove the oven compartment.
2. Slide out the protection panel A
(
see diagram
).
3. Remove the oven burner after unscrewing the
screws V (
see figure
).
The whole operation will be made easier if the oven
door is removed.
4. Unscrew the nozzle using a
special nozzle socket spanner
(
see figure
) or with a 7 mm
socket spanner, and replace it
with a new nozzle that is
suited to the new type of gas
(
see Burner and nozzle
specifications table
).
Adjusting the gas oven
burner’s minimum setting:
1. Light the burner (
see Start-
up and Use
).
2. Turn the knob to the
minimum position (MIN) after
it has been in the maximum
position (MAX) for
approximately 10 minutes.
3. Remove the knob.
4. Tighten or loosen the
adjustment screws on the
outside of the thermostat pin
(
see figure
) until the flame is
small but steady.
! If the appliance is connected to liquid gas, the
adjustment screw must be fastened as tightly as
possible.
5. Turn the knob from the MAX position to the MIN
position quickly or open and shut the oven door,
making sure that the burner is not extinguished.
Adapting the grill
Replacing the grill burner nozzle:
1. Remove the oven burner after loosening screw V
(
see figure
).
2. Unscrew the grill burner nozzle using a special nozzle
socket spanner (
see figure
) or preferably with a 7 mm
socket spanner, and replace it with a new nozzle that
is suited to the new type of gas (
see Burner and
nozzle specifications table
).
! Be careful of the spark plug
wires and the thermocouple
tubes.
! The oven and grill burners do
not require primary air
adjustment.
! After adjusting the appliance
so it may be used with a
different type of gas, replace
the old rating label with a new
one that corresponds to the
new type of gas (these labels
are available from Authorised
Technical Assistance
Centres).
! Should the gas pressure
used be different (or vary slightly) from the
recommended pressure, a suitable pressure
regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to “regulators for channelled gas”.
A
V
V
I
(12 Seiten)
(56 Seiten)
(20 Seiten)
(24 Seiten)
(52 Seiten)
(72 Seiten)
(48 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern