CONTROL PANEL
ACCESSORIES
POTS AND PANS
Only use pots and pans made from ferromagnetic
material which are suitable for use with induction hobs.
To determine whether a pot is suitable, check for the
symbol (usually stamped on the bottom). A magnet
may be used to check whether pots are magnetic. The
quality and the structure of the pot base can alter cooking performance.
RECOMMENDED POT BOTTOM WIDTHS
Place the pot on the required cooking zone before switching the hob on.
For good cooking results, the diameter of the base of the pot should
match the size of the hotplate.
IMPORTANT: The cooking zones will not switch on if pots are not the right
size.
To determine the size of the pot please measure the base of the pot and
refer to recommended pots bottom width table, for perfect usage and
correct pan detection. Each cooking zone has a minimum limit of detecting
pans, which varies depending on the material of the pan being used. You
should therefore use the cooking zone that is most suitable for the diameter
of your pan.
DIAMETER cm MAX cm MINcm
14,5 14,5 10
18 18 12
21 21 15
RECOMMENDED POT POSITION
For best performance, when you use two pots simultaneously, put them
according to the pictures below:
IMPORTANT: To avoid a permanent damage the hob:
• do not use pots with bottoms that are not at;
• do not use metal pots with enamelled bottom;
• do not place hot pots/pans over the control panel.
On / O Control panel lock
Cooking zone controls and corresponding display
DAILY USE
SWITCHING THE HOB ON/OFF
To switch the hob on, press the button for approx. 2 seconds until
the cooking zone displays light up.
To switch o, press the same button until the displays switch o. All the
cooking zones are deactivated.
If the hob has been in use, the residual heat indicator “H” remains lit until
the cooking zones have cooled down.
If within 10 seconds of switching on, no function is selected, the hob
switches o automatically.
SWITCHING ON AND ADJUSTING COOKING ZONES
Place the pot on the desired cooking
zone. Turn on the cooking top. Then
activate the selected cooking zone
by pressing the corresponding
position button. The display shows
“0”. It is possible to select the
required power level, from min. 0 to
max. 9, or booster “P” if available. To increase the power level, push the “+”
button. To decrease the power level push the “−” button.
Power indicator display
Selected cooking zone indicatio
Cooking zone positioning
DEACTIVATION OF COOKING ZONES
To switch o the cooking zone, press the corresponding position button
for more than 3 sec.
The cooking zone switches o and, if still hot, the letter “H” appears on
the zone display.
CONTROL PANEL LOCK
This function locks the controls to prevent accidental activation of the hob.
To activate the control panel lock, switch the hob on and press the Control
panel lock button for three seconds; an acoustic signal and a luminous
indicator near the padlock indicate function activation. The control panel
is locked except for the switching o function.
To deactivate the control lock, repeat the activation procedure. The
luminous dot goes o and the hob is active again.
The presence of water, liquid spilled from pots or any objects resting on
the button below the symbol can accidentally activate or deactivate the
control panel lock.
EN
(24 Seiten)
(10 Seiten)
(72 Seiten)
(20 Seiten)
(40 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern