GB
9
Start-up and use
! The position of the corresponding gas burner or
electric hotplate* is shown on every knob.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
0 Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to
the maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding
knob as far as possible and turning it anticlockwise
towards the maximum setting.
! Note When there is no electricity supply, the
burners can be lit with a match after turning the
control knob to the flame position.
To turn on one of the burners, place a lighted match
or lighter near the burner, press the knob all the way
in and turn it anti-clockwise to the "High" setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the “0” position).
The "double-flame" burner*
This gas burner consists of two concentric flame
rings. Using both flame rings enables a higher
power level to be reached, thus reducing cooking
time with respect to the time required by traditional
burners. The double ring also enables heat to be
distributed across the base of the pan more evenly.
Cookware of all sizes may be used; when cooking
with small recipients use only the inner burner. The
burner is controlled with a single knob.
To light it, press the knob in fully and turn it in an
anticlockwise direction until it reaches the maximum
position
. The burner is equipped with an
electronic lighting system that is activated
automatically when the knob is pressed.
As the burner is fitted with a safety device,As the burner is fitted with a safety device,
As the burner is fitted with a safety device,As the burner is fitted with a safety device,
As the burner is fitted with a safety device, the
knob should be held down for approximately 2-3
seconds, until the automatic device keeping the
flame alight has heated up.
Each burner can be adjusted using the control knob
as follows:
• Off
On and inner ring set to maximum
Inner ring set to minimum
Both rings set to maximum
Both rings set to minimum
To switch off the burner, turn the knob in a clockwise
direction until it stops (when it reaches the “•”
position).
Practical advice on using the burners
To ensure the burners operate efficiently:
• Use appropriate cookware for each burner (see
table) so that the flames do not extend beyond
the bottom of the cookware.
• Always use cookware with a flat base and a
cover.
• When the contents of the pan reach boiling point,
turn the knob to minimum.
Burner
ø Cookware diameter
(cm)
A. Auxilliary 10 - 14
C. Semi-Fishburner 16 - 22
I. Double flame (DCDR
internal)
10 -14
I. Double flame (DCDR
total)
26 - 28
! Make sure the pans do not overlap the edges of
the hob while it is being used
! On the models supplied with a reducer shelf,
remember that this should be used only for the
Double flame internal (DCDR internal) burner when
you use casserole dishes with a diameter under 12
cm.
To identify the type of burner, refer to the designs in
the section entitled, "Burner and Nozzle
Specifications".
(20 Seiten)
(72 Seiten)
(68 Seiten)
(36 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern