Indesit WNF8 T2O X Bedienungsanleitung PDF herunterladen (Seite 5)

Installation

! Before placing your new appliance into operation please read

these operating instructions carefully. They contain important

information for safe use, for installation and for care of the

appliance.

! Please keep these operating instructions for future reference.

Pass them on to possible new owners of the appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free room.

2. Do not obstruct the rear fan grills. The compressor and

condenser give off heat and require good ventilation to

operate correctly and save energy.

3. Leave a space of at least 10 cm between the top part of

the appliance and any furniture above it, and at least 5 cm

between the sides and any furniture/side walls.

4. Place the device far from heat sources (direct sun light,

electric kitchen etc.)

Levelling

1. Install the appliance on a level and rigid floor.

2. If the floor is not perfectly horizontal, adjust the refrigerator

by tightening or loosening the front feet.

Electrical connections

After the appliance has been transported, carefully place it

vertically and wait at least 3 hours before connecting it to the

electricity mains. Before inserting the plug into the electrical

socket ensure the following:

• The appliance is earthed and the plug is compliant with the

law.

• The socket can withstand the maximum power of the

appliance,

• The voltage must be in the range between the values indicated

on the data plate located on the bottom left side (e.g. 220-

240V).

• The socket is compatible with the plug of the appliance. If

the socket is incompatible with the plug, ask an authorised

technician to replace it (see Assistance). Do not use extension

cords or multiple sockets.

! Once the appliance has been installed, the power supply cable

and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should these safety

measures not be observed.

Start-up and use

Starting the appliance

! Before starting the appliance, follow the installation

instructions (see Installation).

! Before connecting the appliance, clean the compartments and

accessories well with lukewarm water and bicarbonate.

! Electronic versions are provided with a motor protection switch

that powers on the compressor only almost 8 minutes after the

starting. The compressor also starts each time the power supply

is cut off whether voluntarily or involuntarily (blackout).

1. Connect the plug and check that the FRIDGE TEMPERATURE

indicator turns on. If the indicator stays off, please press the

ON/OFF button.

2. Set the FRIDGE TEMPERATURE on an average value. After

a few hours it will be possible to insert food in the fridge.

Cooling system

No Frost

The No Frost system circulates cold air continuously to collect

humidity and prevent ice and frost formation. The system

maintains an optimal humidity level in the compartment,

preserving the original quality of the food, preventing the food

from sticking together and making defrosting a thing of the past.

Do not block the aeration cells by placing food or containers in

direct contact with the refrigerating back panel. Close bottles

and wrap food tightly.

Using the refrigerator to its full potential

• Place only cold or lukewarm foods in the compartment•

Remember that cooked foods do not last longer than raw

foods.

• Do not store liquids in open containers: they will increase the

level of humidity in the refrigerator and cause condensation to

form.

COMPARTMENT 3 IN 1 ZONE*

This is the new box which offers maximum flexibility in order to

stock your food in an excellent way.

-store meat, fish and delicate food;

-rapid cooling of hot food from 70°C to 3°C and of other fresh

foods and leftovers

-low temperature defrosting (it inhibits the proliferation of

microorganisms).

You can get the 0°C temperature, in standard conditions, when

the fridge compartment temperature is at about 4°C.

By decreasing the fridge temperature you decrease the CHILLER

compartment temperature too.

* Varies by number and/or position, available only on certain

models.

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit WNF8 T2O X Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühl- und Gefrierschränke Indesit WNF8 T2O X