Indesit OS B 200 H (RU) Bedienungsanleitung Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
INSTRUCTIONS FOR USE
accompanying documents, indicates that this
appliance should not be treated as domestic waste
but must be taken to a special collection centre for the
recycling of electrical and electronic equipment.
When scrapping the appliance, make it unusable by
cutting off the power cable and removing the doors
and shelves so that children cannot easily climb inside
and become trapped.
Scrap the appliance in compliance with local
regulations on waste disposal, taking it to a special
collection centre; do not leave the appliance
unattended even for a few days, since it is a potential
source of danger for children.
For further information on the treatment, recovery and
recycling of this product, contact your competent local
office, the household waste collection service or the
shop where you purchased the appliance.
Declaration of conformity
• This appliance has been designed for preserving
food and is manufactured in compliance with
Regulation (CE) No. 1935/2004.
• This appliance has been designed, manufactured
and marketed in compliance with:
- safety objectives of the “Low Voltage” Directive
2006/95/CE (which replaces 73/23/CEE and
subsequent amendments);
- the protection requirements of Directive “EMC”
2004/108/EC.
BEFORE USING THE APPLIANCE
To ensure best use of your appliance, carefully
read the operating instructions which contain a
description of the product and useful advice.
Keep these instructions for future reference.
1. After unpacking the appliance, make sure it is not
damaged and that the door closes properly. Any
damage must be reported to the dealer within 24
hours of delivery of the appliance.
2. Wait at least two hours before switching the
appliance on, to ensure that the refrigerant circuit is
fully efficient.
3. Clean the inside of the appliance before using it.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
Transportation and storage rules
Packaged product should be stored at a relative
humidity of 80% in closed rooms (indoors) with
natural ventilation.
If the product is not used in a long period of time, it
must be unplugged from the electrical network. Also
you need to remove all products, defrost it and clean
all the cameras. The doors after cleaning should be
left slightly opened in order to prevent the appearance
of bad odor.
The product must be transported in vertical position
(in operating postion) and fastened securely in any
type of roofed transport.
Do not expose the product to impact loads.
INSTALLATION
Be careful not to damage the floors (e.g. parquet)
when moving the appliance.
• Make sure the appliance is not near a heat source.
• Install and level the appliance on a floor strong
enough to take its weight and in a place suitable for
its size and use.
• The appliance is arranged for operation in places
where the temperature comes within the following
ranges, according to the climatic class given on the
rating plate. The appliance may not work properly if it
is left for a long time at a temperature outside the
specified range.
Climatic Class Amb. T. (°C)
SN From 10 to 32
N From 16 to 32
ST From 16 to 38
T From 16 to 43
• Make sure the voltage specified on the rating plate
corresponds to that of your home.
Connection to the power grid/electrical network
(to the mains)
Refrigerator is made by the 1 class degree of
protection from the electric shock and is connected to
the mains power via a two-pole socket outlets.
Before plugging make sure that:
- the mains voltage corresponds with the
specifications on the label (220-240V);
- the third ground prong of the electrical socket is
directly connected to the ground wire of the supply
mains cable (connecting wire must be rated for a
current of at least 10A);
- socket and the plug of the same type; If the plug does
not fit the socket, the socket should be replaced with
the corresponding plug of the supply cord (operation
must be performed by a qualified electrician).
Seitenansicht 2
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare