Indesit TCD G51 AX (EU) Bedienungsanleitung PDF herunterladen (Seite 6)

GB

6

Maintenance and Care

Switching off the electricity

! Unplug your dryer when not using it,

when cleaning it and during all

maintenance operations.

Clean the filter after each cycle

The filter is an important

part of your dryer:

it accumulates lint and

fluff that is formed while

drying.

When finished drying, clean the filter by

rinsing it under running water or with your

vacuum cleaner. Should the filter become

clogged up, the airflow inside the dryer will

be seriously compromised: drying times

lengthen and you will consume more

energy. It may also damage your dryer.

The filter is found in front of the dryer trim

(see diagram on next page).

Removing the filter:

1. Pull the plastic grip of

the filter upwards.

2. Clean the filter and

replace it correctly.

Ensure the filter is fully

located flush into

the tumble dryer trim.

! Do not use the dryer without replacing

the filter.

Cleaning the heat pump filter unit

Periodically (every 5 drying cycles) remove

the heat pump filter unit and clean any

build up of fluff from the surface of the filter.

However, we recommend that you clean

this filter after EVERY drying cycle to

optimise the dryers performance.

To removing the heat pump filter unit:

1. Unplug the dryer and open the door.

2. Pull open the heat pump filter unit cover

(see diagram on next page).

Release the 4 clips to the vertical position

then pull the filter unit towards you.

3. Separate the two parts

of the filter and clean

the surface of the filter.

! The front of the heat pump is made

from thin metal plates. Take care that you

do not damage these or cut yourself when

cleaning, removing or replacing the heat

pump filter unit.

Whenever you clean the heat pump filter

unit always clean any build up of fluff from

the surface of the metal plates.

4. Carefully clean this fluff

off with a damp cloth,

sponge or a vacuum

cleaner.

Never use your fingers.

5.Reassemble the two parts of the filter,

clean the seals and replace with the 4

clips in the horizontal position, make

sure that the catches are secure.

1 2 3 4 5 6 7 8 9 10 11 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare