Indesit TCD G51 AX (EU) Bedienungsanleitung PDF herunterladen (Seite 11)

Choosing a programme

1. Plug the dryer into the electrical socket.

2. Sort your laundry according to fabric type (see Laundry).

3. Open the door and make sure the ﬁ lter is clean and in

place and the water container is empty and in place (see

Maintenance).

4. Load the machine and make sure items are not in the way

of the door seal. Close the door.

5. If the Display is not lit: Press the ON/OFF button .

6. Press the Programmes Selection button that corresponds

with the type of fabric being dried by checking the

Programmes Table (see Programmes) as well as the

indications for each type of fabric (see Laundry).

- if the M button is selected; steps 7 and 8 are not required

(see below).

7. Choose Timed Drying or Dryness Levels option:

- If Timed Drying press and release the Timed button until

the required time is displayed

or - To change from default dryness setting, press and

release the Dryness Levels button until required level is

indicated.

! See Programmes Table, for more details: availability of

Dryness Levels, Timed Dry and Options.

8.Set a delay time and other options if necessary (see The

Display).

9.Press the Start/Pause button

to begin. The display

will show the estimated time to end. During the drying

programme, you can check on your laundry and take out

items that are dry while others continue drying. When you

close the door again, press the Start/Pause button

order to resume drying.

If you open the door to check your laundry you will extend

the drying time as the heat pump compressor will not start for

5 minutes after you close the door and press the Start/Pause

button (see The Controls).

My Cycle button:

First time you press this button the display will show

PRESS AND HOLD TO STORE

After selecting your favorite programme and options you can save these settings by pressing and holding in the My Cycle

button for at least 5 seconds, the top line will show a ﬂ ashing M followed by the selected programme. The

buzzer will then beep and the second line of the display shows

MEMORY

The next time you need this programme press the M, button, then the Start/Pause button (and this programme will run.

If you wish, you can change your stored favorite, by selecting a new programme and/or options and press and hold

in the M button (as above).

10. During the last few minutes of Drying Programmes,

before the programme is completed, the ﬁ nal COOL

TUMBLE phase is entered (fabrics are cooled), this phase

should always be allowed to complete.

11. At the end of the drying cycle a message is displayed:

- if

END OF CYCLE, CLEAN FILTER AND EMPTY WATER BOTTLE

is shown, the buzzer will beep 3 times (Note: If the SOUND

option was selected the buzzer beeps 3 times every 30

seconds for 5 minutes).

- if

END OF CYCLE, CREASE CARE

is shown, Crease Care

option has been selected and if you do not remove the

laundry immediately, the dryer will tumble occasionally for 10

hours or until you open the door, the buzzer will beep 3 times

to conﬁ rm the programme is completed.

12. Open the door, take the laundry out, clean the ﬁ lter and

replace it. Empty the Water Container and replace it (see

Maintenance).

13. Unplug the dryer.

Start and Programmes

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit TCD G51 AX (EU) Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrische Wäschetrockner Indesit TCD G51 AX (EU)