Indesit XWDE-861480X-W-DE Bedienungsanleitung PDF herunterladen (Seite 16)

16

GB

! This instruction manual should be kept in a

safe place for future reference. If the washer-

dryer is sold, transferred or moved, make

sure that the instruction manual remains with

the machine so that the new owner is able to

familiarise himself/herself with its operation

and features.

! Read these instructions carefully: they

contain vital information relating to the safe

installation and operation of the appliance.

Unpacking and levelling

Unpacking

1. Remove the washer-dryer from its packaging.

2. Make sure that the washer-dryer has not

been damaged during the transportation

process. If it has been damaged, contact the

retailer and do not proceed any further with

the installation process.

3. Remove the 4

protective screws

(used during

transportation)

and the rubber

washer with the

corresponding

spacer, located on

the rear part of the

appliance (see figure).

4. Close off the holes using the plastic plugs

provided.

5. Keep all the parts in a safe place: you will

need them again if the washer-dryer needs to

be moved to another location.

! Packaging materials should not be used as

toys for children.

Levelling

1. Install the washer-dryer on a flat sturdy floor,

without resting it up against walls, furniture

cabinets or anything else.

2. If the floor is

not perfectly level,

compensate for

any unevenness

by tightening or

loosening the

adjustable front

feet (see figure); the

angle of inclination,

measured in relation

to the worktop, must

not exceed 2°.

Levelling the machine correctly will provide

it with stability, help to avoid vibrations and

excessive noise and prevent it from shifting

while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow

a sufficient ventilation space underneath the

washer-dryer.

Connecting the electricity and

water supplies

Connecting the water inlet hose

1. Connect the “Water

Block” (A) device

to a cold water tap

using a 3/4 gas

threaded attachment,

then perform the

connection by

screwing the supply

hose to the device.

Before performing the

connection, allow the

water to run freely until it is perfectly clear.

For a correct installation of the device,

follow the instructions given in the “Water

Block” packaging.

! The device is already adjusted for the correct

operation of the washing machine and therefore

it is recommended not to change its settings.

2. Connect the

inlet hose to the

washer-dryer by

screwing it onto the

corresponding water

inlet of the appliance,

which is situated on

the top right-hand

side of the rear part

of the appliance (see

figure).

3. Make sure that the hose is not folded over

or bent.

! The water pressure at the tap must fall within

the values indicated in the Technical details

table (see next page).

! If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

Installation

A

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare