Indesit IDL 410 S FR.C Bedienungsanleitung Seite 15

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 24
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 14
13
EN
Salt ......
Salt
The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form
on the dishes and utensils.
The appliance is equipped with a special softener that
uses a salt specifically designed to eliminate lime and
minerals from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is
located beneath the lower
rack and should be filled
as follows:
1. Remove the lower rack
and then unscrew and
remove the cap from the
salt container;
2. If you are filling the
container for the first time,
fill it with water;
3. Place the end of the
funnel (supplied) into the hole and introduce about 2 kg
of salt. It is normal for a small amount of water to come
out of the salt container.
4. Carefully screw the cap back on.
The salt container should be filled after about every 30
wash cycles..
Warning: To prevent rust from forming, we advise you
to load the salt before starting a wash cycle.
If the salt container is not filled, the water softener
and the heating element may be damaged as a result.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the
amount of salt consumed based on the harness of the
water used. This is intended to
optimize and customize the level of
salt consumption so that it remains
at a minimum.
Your Local Water Board can supply
the degree of hardness of the water
in your area.
To adjust salt consumption, proceed
as follows:
1) Unscrew the cap from the salt container.
2) There is a ring on the container with an arrow on it (see
figure to the side), if necessary, rotate the ring in the an-
ticlockwise direction from the "_" setting towards the "+"
sign, based on the hardness of the water being used.
It is recommended that adjustments be made in accord-
ance with the following schema:
Hardness of the water
°dH °fH °mmol/l
Selector
knob
position
Salt
consumption
(grams/cycle)
Autonomy
(cycles/2 kg)
0 - 10 0 - 17 0 - 1.7 / 0 /
10 – 25
18 – 44
1.8 – 4.4
- 20 60
25 – 50
45 – 89
4.5 – 8.9
MED 40 40
> 50 > 89 > 8.9 + 60 25
Seitenansicht 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare