Indesit DPG 36 A IX.R Bedienungsanleitung PDF herunterladen (Seite 14)

Anti-condensation strip*

After installing the dishwasher, open the door and stick the

adhesive transparent strip under the wooden shelf in order to

protect it from any condensation which may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before running

the first wash cycle, completely fill the salt dispenser with water

and add only then approximately 1 kg of salt (

see chapter entitled

Rinse aid and refined salt

). The water may overflow: this is normal

and is not a cause for concern. Select the water hardness value

(

see chapter entitled Rinse aid and refined salt

). - After the salt

has been poured into the machine, the LOW SALT indicator light

switches off.

If the salt container is not filled, the water softener and the

heating element may be damaged as a result.

Electrical connection

Before inserting the plug into the electrical socket, make sure

that:

• The socket is earthed and complies with current regulations.

• The socket can withstand the maximum load of the appliance,

which is indicated on the data plate located on the inside of the

door (

see chapter entitled Description of the appliance

• The power supply voltage falls within the values indicated on

the data plate on the inside of the door.

• The socket is compatible with the plug of the appliance. If this

is not the case, ask an authorised technician to replace the

plug (

see Assistance

); do not use extension cables or multiple

sockets.

Once the appliance has been installed, the power supply

cable and the electrical socket should be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be replaced

by the manufacturer or its Technical Assistance Service in order to

prevent all potential hazards. (See Assistance)

The Company shall not be held responsible for any incidents

that occur if these regulations are not observed.

ECODESIGN REGULATION

ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a normal soil

level and is the most efficient in terms of energy and water consumption for this type of crockery. To reduce consumption even further,

only run the dishwasher when it is full.

Standby consumption: Left-on mode consumption: 3 W – Off mode consumption: 1,3 W

Consumption data table for the main cycles

* Cycle data refers to the values recorded in a laboratory, in accordance with European standard EN 50242.

** Data is obtained by recording values when the appliance is operational and loaded with user crockery.

Standard conditions

User conditions

Energy consumption

(kWh/cycle)

Water consumption

(l/cycle)

Duration

(min/cycle)

Energy consumption

(kWh/cycle)

Water consumption

(l/cycle)

Duration

(min/cycle)

INTENSIVE

1,60 16 150 1,40 15 135

NORMAL

1,30 16 120 1,10 15 110

Technical data

Dimensions

width 59.5 cm

height 82 cm

depth 57 cm

Capacity 12 standard place-settings

Water supply

pressure

0,05 ÷ 1MPa (0.5 ÷ 10 bar)

7,25 – 145 psi

Power supply

voltage

See appliance data plate

Total absorbed

power

See appliance data plate

Fuse See appliance data plate

This dishwasher conforms to the

following European Community

Directives:

-2006/95/EC (Low Voltage)

-2004/108/EC (Electromagnetic

Compatibility)

2009/125/EC (Comm. Reg,

1016/2010) (Ecodesign)

-97/17/EC (Labelling)

-2002/96/EC (Waste Electrical

and Electronic Equipment WEEE)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit DPG 36 A IX.R Bedienungsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Indesit DPG 36 A IX.R