Indesit DI 67 Bedienungsanleitung PDF herunterladen (Seite 11)

Cleaning and Special Maintenance

Filter Assembly

If you want consistent good results from your dishwasher,

you need to clean the filter assembly.

The food particles

are removed from

the wash water,

allowing it to be

recirculated during

the cycle, filtered

perfectly. For this

reason, it is a good

idea to remove the

larger food

particles trapped

inside the cup “C” and the semi-circular filter A after each

wash; pull the cup handle upwards to remove them. Just

rinse them under running water.

The entire filter assembly should be cleaned thoroughly once

a month: cup C + semi-circular filter A + cylindrical filter B.

Rotate filter “B” anticlockwise to remove it.

For cleaning, use a non metallic brush.

Reassemble the filter parts (as shown in the figure) and

reinsert the whole

assembly into the

dishwasher. Position it

into its housing and

press downwards.

The dishwasher is not

to be used without

filters. Improper

replacement of the

filters may reduce the

efficiency of the wash and even damage your dishwasher.

Cleaning the Sprayer Arms

It may happen that food particle become encrusted on the

sprayer arms and block the holes (see "Close up view

(interior)", letters F-I). Check the sprayer arms periodically

and clean them when needed.

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter (see figure 2 under

"Installation") located on the outlet of the water supply

tap. After turning off the water tap, unscrew the end of

the water supply hose, remove the filter and clean it carefully

under running water. Then, return the filter to its place and

tighten the water supply hose back into position.

Troubleshooting

It may occur that the dishwasher does not function or does

not function properly. Before calling for assistance, let us

see what can be done first: have you forgot to press one of

the buttons or to perform an essential operation?

The Dishwasher Does Not Start

Have you checked whether:

- the plug is pushed into the socket correctly;

- the power is on in the house;

- the door is closed properly;

- the ON-OFF switch is on "ON";

- the water supply is turned on.

The Dishwasher Does Not Load Water

Have you checked whether:

- the water is turned on and the hose is connected properly;

- the water supply to the house is on and has sufficient

pressure;

- the water supply hose is crimped or bent;

- the filter for the water supply hose is clogged.

The Dishes Are Not Clean

Have you put the right amount of detergent into the

dispenser?

Is the wash cycle suitable for the dishes you have placed

inside the appliance?

Are the filter and microfilter clean?

Can the sprayer arms turn freely?

The Dishwasher Does Not Drain

Have you checked whether:

- the drain hose is crimped or bent.

Lime Deposits or a White Film Form on the Dishes

Have you checked whether:

- the lid to the salt container is closed properly;

- the rinse aid dosage is correct.

Error messages

Your dishwasher is equipped with a safety system which is

able to detect any operating anomalies. These anomalies

are reported by one or two cycle phase indicator lights "G"

flashing rapidly. Take a note of which lights are flashing,

turn the appliance off and call for technical assistance.

Tap off alarm

If you have forgotten to turn the water tap on, your appliance

will remind you of this by sounding a few short beeps for a

few minutes. Turn the tap on and your appliance will start

up again after a few minutes. Were you to be absent when

these beeps are sounded, the appliance will be blocked

automatically and cycle phase 2 and 3 indicator lights (wash

and rinses) will flash rapidly. Turn the appliance off at the

ON-OFF button, turn on the water tap and wait

approximately 20 seconds before turning the appliance back

on, now the program will start.

If, despite all these checks, the dishwasher still does not

function and/or the problem persists, contact the nearest

authorised service centre and provide them with the

following information:

- the nature of the problem;

- the model type number (Mod. ...) and the serial number

(S/N ....), which are indicated on the plate located on the

side of the inner part of the door.

Never call on unauthorised technicians and refuse to

allow parts to be installed that are not original spare

parts

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit DI 67 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Indesit DI 67