Indesit B 40 L/CS SF Bedienungsanleitung PDF herunterladen (Seite 19)

Electrical connection

THE APPLIANCE MUST BE EARTHED

The hobs are designed to work with alternating current at the

supply voltage and frequency indicated on the rating plate

(situated under the hob or at the end of the instruction

booklet). Make sure that the local supply voltage corresponds

to the voltage indicated on the rating plate.

Connecting the supply cable to the mains electricity supply

For models supplied without a plug, fit a standard plug,

suitable for the load indicated on the rating plate, onto the

cable and connect to a suitable socket.

To connect directly to the mains supply, a double-pole switch

with a contact separation of at least 3 mm suitable for the load

and complying with current standards and regulations, must

be fitted between the appliance and the mains supply outlet.

The yellow-green earth wire must not be interrupted by the

switch. The supply cable must be in such a position that no

part of it can reach a temperature of 50 °C above room

temperature. For installation above a built-under oven, the

hob and the oven must be connected separately to the

electricity supply both for safety reasons and for easy removal

of the oven if necessary. Do not use adapters or shunts as

they could cause heating or burning.

Before connecting to the power supply, make sure that:

• the limiter valve and the domestic system can withstand

the load from the appliance (see rating plate);

• the supply system is efficiently earthed according to

standards and laws in force;

• the socket or double-pole switch are easily accessible when

the appliance is installed.

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow - Earth

Blue - Neutral

Brown - Live

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

Connect the Green & Yellow wire to terminal marked “E” or

or coloured Green or Green & Yellow. Connect the Brown

wire to the terminal marked “L” or coloured Red. Connect the

Blue wire to the terminal marked “N” or coloured Black.

FAILURE TO OBSERVE THE ACCIDENT-PREVENTION

REGULATIONS RELIEVES THE MANUFACTURER OF ALL

LIABILITY.

Replacing the cable

Use a rubber cable of the type H05RR-F with a suitable cross

section 3 x 0.75 mm². The yellow-green earth wire must be 2-3

cm longer than the other wires.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit B 40 L/CS SF Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Indesit B 40 L/CS SF