Indesit TCD 851 AX (EU) Bedienungsanleitung PDF herunterladen (Seite 15)

Cleaning the heat pump filter unit

Periodically (every 5 drying cycles) remove the heat

pump filter unit and clean any build up of fluff from the

surface of the filter.

However, we recommend that you clean this filter after

EVERY drying cycle to optimise the dryers performance.

To removing the heat pump filter unit:

1. Unplug the dryer and open the door.

2. Pull open the heat pump filter unit cover (see diagram).

Release the 4 clips to the vertical position then pull

the filter unit towards you.

3. Separate the two parts of the

filter and clean the surface of

the filter.

! The front of the heat pump is made from thin

metal plates. Take care that you do not damage

these or cut yourself when cleaning, removing or

replacing the heat pump filter unit.

4. If there is any build up of fluff on the plates, carefully

clean this off with a damp cloth, sponge or a vacuum

cleaner. Never use your fingers.

5. Reassemble the two parts of the filter, clean the

seals and replace with the 4 clips in the horizontal

position, make sure that the catches are secure.

Cleaning the dryer

●

External parts in metal or plastic and rubber parts

can be cleaned with a damp cloth.

●

Periodically (every 6 months) vacuum the front air

intake grille and vents at the rear of the dryer, to

remove any build up of fluff, lint or dust. Also to

remove accumulation of fluff from the front of the

condenser and filter areas, clean occasionally with

a vacuum cleaner.

! Do not use solvents or abrasives.

! Your dryer uses special bearing components which

do not need lubrication.

! Have your dryer checked regularly by authorised

technicians to ensure electrical and mechanical safety

(see Service).

Switching off the electricity

! Unplug your dryer when not using it, when cleaning

it and during all maintenance operations.

Clean the filter after each cycle

The filter is an important part of your dryer:

it accumulates lint and fluff that is formed while drying.

When finished drying, clean the filter by rinsing it

under running water or with your vacuum cleaner.

Should the filter become clogged up, the airflow inside

the dryer will be seriously compromised: drying times

lengthen and you will consume more energy. It may

also damage your dryer.

The filter is found in front of the dryer trim (see diagram).

Removing the filter:

1. Pull the plastic grip of the filter upwards (see diagram).

2. Clean the filter and replace it correctly.

Ensure the filter is fully located flush into the tumble

dryer trim.

! Do not use the dryer without replacing the filter.

Check the drum after each cycle

Turn the drum manually in order to remove small items

(handkerchiefs) that could have been left behind.

Cleaning the drum

! Do not use abrasives, steel wool or stainless steel

cleaning agents to clean the drum.

A coloured film may start to appear on the stainless

steel drum, this may be caused by a combination of

water and, or cleaning agents such as fabric conditioner

from the wash. This coloured film will not affect the

dryer performance.

Empty the water container after each

cycle

Pull the container out of the dryer and empty it into a

sink or other suitable drain.

Replace the water container securely.

Always check and empty the container before you

start a new drying programme.

Maintenance and Care

Water container

Handle

Heat pump filter

unit cover

Clips

Air intake

Filter

Heat pump filter unit

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit TCD 851 AX (EU) Bedienungsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wäschetrockner Indesit TCD 851 AX (EU)