Indesit IDV 75 (UK) Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wäschetrockner Indesit IDV 75 (UK) herunter. Indesit IDV 75 (UK) Instruction for Use Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Instruction booklet
TUMBLE DRYER
Step 1
Open the door of your dryer
Step 2
Pull out the filter (using the
two finger grips)
Step 3
Clean the fluff off the filter
and replace it correctly.
Ensure that the filter is
pushed fully home.
Step 4
Make sure the filter is pushed fully home
NEVER run the dryer without the filter in position
Failure to clean the filter after EVERY drying
cycle will affect the drying performance of your
machine. It will take longer to dry and as a result
will use more electricity during drying.
At least every two or three months you MUST
clean fluff build up around the filter housing and
the vent tube.
IDV 75 UK
IDV 75 S UK
IDV 75B K UK
WHERE TO INSTALL THE TUMBLE DRYER
10
m
m
15 mm
15 mm
15 mm
15 mm
If you are going to install the
appliance under a work
counter be sure to leave a
10 mm space between the
top and any other objects on
or above the machine and a
15 mm space between the
sides and any kitchen units
or walls to ensure proper air circulation. The
dryer must never be installed behind a lockable
door, a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
The appliance must be installed with the rear
surface placed against a wall.
VENTILATION
When the dryer is in use there has to be adequate
ventilation to avoid the back flow of gases into
the room from appliances burning other fuels,
including open fires. The vent tube should not exceed 2.4
metres in length. The tube should be kept clear of the air intake
vent and kinks or ‘U’ bends must be avoided as these will obstruct
the tube and trap condensation.
VENTING
Wall mounting
Keep the tube as short and as straight
as possible to prevent condensation
forming in the vent pipe.
The duct in the wall should slope
slightly downwards.
Window mounting
The hole in the window should be as
low down as possible and the tube should be kept as short as
possible.Depending on how often you use your tumble dryer, it is
essential that areas A and B are checked periodically to remove
lint or debris.
This symbol reminds you to read this booklet.
B
A
Open window venting
The end of the tube should be
directed downwards, to prevent
warm moist air from condensing in
the room or dryer.
Do not discharge exhaust
air into a flue which is used
for exhaust fumes from
other appliances that burn gas or other fuels.
Do not discharge exhaust air into an extraction system or any duct
with an extractor fan. This will affect the way the thermal controls
operate and can result in a fire hazard.
ELECTRICAL CONNECTIONS
The socket must be grounded. The power supply
cord should be checked periodically. If the
supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazar
LEVELLING YOUR DRYER
The dryer must be installed level for
correct operation. When you have
installed your dryer in its final location
check that it is first level side to side and
then back to front.
If the dryer is not level use a wooden
block to support it while adjusting the
two front legs up or down until your dryer is level.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before you
use it clean the inside of the drum to remove any
dust that could have accumulated during transport.
Air intake vent
Do not block or obstruct
Caution: Hot!
Vent Tube fitted here
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Instruction booklet

Instruction bookletTUMBLE DRYERStep 1Open the door of your dryerStep 2Pull out the filter (using the two finger grips)Step 3Clean the fluff off the filter

Seite 2 - Warnings

Warnings! This appliance has been designed and built according to international safety standards. These warnings are given for safety reasons and must

Seite 3 - Troubleshooting

Dryer DescriptionThe TIMER knob: the 0 position swithes off the dryer.The TIMER knob sets the drying time: rotate it clockwise, NEVER COUNTER-CLOCKWIS

Seite 4 - 19508940607

1950894060710/2017OUR ADVISORS WILL REQUIRE THE FOLLOWING INFORMATION:• name, address and postal code• telephone number• type of malfunction• date

Kommentare zu diesen Handbüchern

Keine Kommentare