Indesit SD 125 Bedienungsanleitung PDF herunterladen (Seite 13)

Installation and Setting up

Proper installation of the appliance is essential to

ensure the best and most efﬁcient performance of

your appliance.

Ventilation

The compressor and condenser generate heat and,

therefore, need to be ventilated properly. Rooms with less

than perfect ventilation are not very suited for installation

of the appliance. Therefore, it should be installed in a

room with an opening (window or French window) that

provides the appropriate amount of air recirculation. It is

also important that the room should not be too humid.

During installation, make sure not to cover or obstruct the

grates that allow proper ventilation of the appliance. For

proper ventilation of the appliance, you must leave:

– a space of at least 10 cm between the top part and any

cabinets above it;

– a space of at least 5 cm between the sides of the

appliance and any adjacent cabinets/walls.

Away from Heat

Avoid positioning the appliance in a place where it is

directly exposed to sunlight or near an oven, cook top or

the like.

Levelling

The ﬂoor should be perfectly levelled; if not, you can

adjust the feet at the front of the appliance.

Before placing foodstuffs in the refrigerator, clean the

interior well with warm water and baking soda.

After having plugged the appliance in, make sure that

pilot lamp is light.

Set thermostat knob onto a medium position and can

place food in the fridge after only a few hours.

Earthing

Before making the electrical connection, check that the

voltage shown on the data plate, that you will ﬁnd on the

bottom left hand side of the appliance next to the crisper,

corresponds to that of your mains and that the socket is

earthen in conformity with all current electrical regulations.

If the system is not earthen, the manufacturer declines all

liability for consequent damages or losses. Do not use

adapters or multiple sockets.

Check the power load

The electrical socket must support the maximum power

load of the appliance shown on the data plate (on the

bottom left hand side of the appliance next to the

crisper).

Before plugging the appliance to the mains

Set the appliance upright and wait at least 3 hours before

plugging the appliance into the mains to ensure proper

performance.

This appliance complies with the following

Community Directives:

- 73/23/EEC of 19.02.73 (Low Voltage) and

subsequent amendments;

- 89/336/EEC of 03.05.89 (Electromagnetic

Compatibility) and subsequent amendments;

- 2002/96/EC (WEEE).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit SD 125 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühlschränke Indesit SD 125