Indesit KD3G2S/IR Bedienungsanleitung PDF herunterladen (Seite 8)

• remove screw “V” and then the oven burner;

• Unscrew the oven burner nozzle using the socket spanner for the nozzles “Z”, or a 7 mm socket spanner,

and replace it with a nozzle suited to the new type of gas (see Table 1).

Take particular care handling the spark plug wires and the thermocouple pipes.

• Replace all the parts, following the steps described above in the reverse order.

b) Minimum regulation of the gas oven burner with thermostat:

• light the burner as described in the paragraph “the oven knob” of the instruction booklet.

• turn the knob to Max for about 10 minutes and then turn the knob to the Min setting;

• remove the knob;

• regulate the screw positioned outside the thermostat pin until the flame is small but steady.

N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.

• check that the burner does not turn off when you turn the knob from Max to Min and and when you open

and close the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

• remove the screw and then slide out the grill burner “V” (see Fig. E);

• unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. F) or better still

a 7 mm socket spanner; replace the nozzle with a nozzle for the new type of gas (see table 1).

Fig. E Fig. F

Important

On completion of the operation, replace the old rating sticker with one indicating the new type of gas used.

This sticker is available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to

fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relative to

“regulators for channelled gas”.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Keine Kommentare

Indesit KD3G2S/IR Bedienungsanleitung Seite 8