Indesit TCD851 XB IT/HA Bedienungsanleitung Seite 28

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 88
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 27
GB
28
Start and Programmes
Timed Drying
Temporizzato
Timed (Temporizzato) programmes table: First select a programme (see Programmes Table).
(0:20, 0:40,
1:00, 1:20, 1:40,
2:00 or 2:20
Hours:Minutes)
Always use Timed Drying
for loads less than 1kg, or
if you prefer a different
dryness result.
The heat setting depends
on the programme
(material option) selected.
Consult suggested drying times
(see Laundry).
The last 10 minutes of these
programmes is the Cool Tumble
phase .
1. Press and release the Timed
Temporizzato button until the display
shows the required selection. Each
press advances , , , , ,
, then and then repeats.
Delicates have maximum time of .
When is displayed, Automatic
Livelli Asciugatura option is available
if you change your mind.
2. Select any Options if required.
3. Press the Start/Pausa Avvio/Pausa
button .
Options available:
Alarm Allarme
Time Delay Partenza Ritardata
Pre Care Antipiega Pre Asciugatura
Post Care Antipiega Post Asciugatura
! Warning, after pressing the Start/Pause Avvio/Pausa
button , the programme cannot be changed. To
change a selected programme, press the Start/Pause
Avvio/Pausa button , the light flashes Amber to
indicate the programme is paused. Select the new
programme and any options required, the light will
then flash green. Press the Start/Pause Avvio/Pausa
button , again and the new programme will start.
Option buttons/indicators
These buttons are used to customise the selected
programme to your requirements. A programme must
have been selected, by pressing a programme selection
button, before an option can be selected. Not all
options are available for all programmes (see
Programmes Table). If an option is not available and
you press the button, the buzzer will beep 3 times. If
the option is available the indicator, on the display unit
next to the bottom buttons, lights to show that the
option has been selected.
Time Delay: Partenza Ritardata
The start of some programmes (see The Display and
Start and Programmes) can be delayed for up to 24
hours. Ensure the water container is emptied before
setting a delayed start.
Pre Care: Antipiega Pre Asciugatura
This option is only available if a delayed start has
been selected. It tumbles the clothes occasionally
during the delayed period to help prevent creases
developing.
Alarm: Allarme
Available on all programmes and allows the buzzer to
give a signal at the end of the drying cycle, to remind
you that the clothes are ready to be removed.
Post Care: Antipiega Post Asciugatura
When available and selected, the clothes are
occasionally tumbled after the end of the drying and
cool tumble cycles, to help prevent creases
developing should you not be available to remove the
load immediately the programme is complete.
TIME DISPLAY
The display shows either the amount of time delay
remaining or an indication of the amount of time left for
a drying programme (see The Display).
The delay or time to end is displayed in hours and
minutes and counts down each minute.
When timed programmes are selected the time
displayed throughout the cycle is the actual time
The Controls
88:88
remaining.
When an Automatic programme is selected, the time
displayed is an estimate of the time remaining. When
the programme is selected the display shows the time
required to dry a full load, after around 10 minutes the
controller calculates a better estimate of the cycle time.
The colons between the hours and minutes in the
display flash to show that the time is counting down.
The display also shows if there is a problem with your
dryer, if this occurs the display will show F followed by
a fault code number (see Troubleshooting).
Empty Water Container
(If you have plumbed your dryer to a drain this message
can be ignored, as there is no need to empty the water
container).
Messages are displayed to reminds you to empty the
water container.
If the water container fills during a programme, the
heater turns off and the dryer does a period of Cool
Tumble. After this it stops and a message tells you to
EMPTY THE WATER CONTAINER .
You must empty the water container and restart the
dryer or the clothes will not dry. After re-starting the
dryer the message will take a few seconds to go out.
To avoid this always empty the water container each
time you use the dryer (see Maintenance).
Door Opening
Opening the door during a programme will stop the
dryer and have the following effects:
The display shows PAUSED .
During a delay phase the delay will continue to
count down. The Start/Pause Avvio/Pausa button
must be pressed to resume the delay programme.
The display will change to show current status.
During the drying part of the programme, the
colons on the display stop flashing to show that
the time has stopped counting down.
The Start/Pause Avvio/Pausa button must be
pressed to resume the programme. The display
will change to show the current status, the colons
flash and count down continues.
During the Post Care Antipiega Post Asciugatura
phase, the programme ends.
Pressing the Start/Pause Avvio/Pausa button will
restart a new programme from the beginning.
Note
If you have a power cut, switch off the power or
remove the plug. When power is restored, press the
Start/Pause Avvio/Pausa button and the programme
will resume.
Seitenansicht 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Kommentare zu diesen Handbüchern

Keine Kommentare