Indesit AQC9 BF7 T1 (EX) Bedienungsanleitung PDF herunterladen (Seite 48)

The Controls

• Programme knob

! Warning, if after pressing the start button the programme

knob position is changed, the new position will NOT change

the programme selected.

To change programme press Start/Pause Button

to pause

the programme, the light flashes Amber, select new programme

and any option, the light will then flash green. Press the Start/

Pause Button

and the new programme will start.

• Option Buttons/ Lights

These buttons are used to customise the selected

programme to your requirements. Not all options are

available for all programmes (see Start and Programmes).

If an option is not available and you press the button, the

buzzer will beep three times. If the option is available there

will be one beep and the option light next to the button lights

to confirm the selection.

• ECO Light

This light is illuminated when you select programme options

that will use less energy than the default setting. Examples

are if you choose an Automatic or sensing programme or

use a timed dry setting less than the default time. This light

does not indicate that the optimum setting for energy use

has been selected; it only shows you that your selected

options will use less energy.

• Progress (

Drying, Cool tumble, ) Lights

The Progress lights show you the status of the programme. At

each stage of the programme the corresponding light turns on.

• Delay Timer

The start of some programmes (see Start and Programmes)

can be delayed for up to 24 hours (see The Display).

Ensure the water bottle is emptied and the filter is cleaned

before setting a delayed start.

• Extra Care

The Anti-ageing function for Cottons helps to maintain the

brightness of your laundry for longer thanks to the use of the

right drum rotation (reduced in the last part of cycle) and the

correct drying temperature.

Note: It cannot be used with the “Ready to Wear”,

“Cupboard Dry” and “Light Dry” dryness levels

• Sound

A buzzer sounds at the end of the drying cycle to signal that

the programme has ended and the garments are ready to be

removed. If you have selected the Crease Care option, this

option is not available.

• Crease Care

When a delayed start and this option have been selected the

clothes are tumbled occasionally during the delayed period

to help prevent creases developing.

After end of the drying and cool tumble cycles, the clothes

are occasionally tumbled to help prevent creases developing,

should you not be available to remove the load immediately

after the programme is complete. The

light is on during

this phase after end of the cycle and the start/pause light

flashes amber. flashes amber. If you have selected the

Sound option, this option is not available.

• High Heat

When a drying time is selected, pressing this button sets

a high heat drying and the indicator light above the button

lights up.

• Empty Water Clean Filter Light

“H2O”

(If you have plumbed your dryer to a drain the

light can be

ignored for the water bottle, as there is no need to empty the

water container). When

is on (not flashing) it reminds you to

empty the water container. If the water container fills during a

programme, the heater turns off and the dryer does a period

of Cool Tumble then the light flashes and the buzzer sounds.

You must empty the container and restart the dryer or the

clothes will not dry. After re-starting the dryer the light will take

a few seconds to go out. To avoid this always empty the water

container each time you use the dryer (see Maintenance).

! Please note that you ALWAYS have to clean the filter even if

you have plumbed your dryer to a drain.

• Door Opening

Opening the door (or pressing the Start/Pause Button) during a

programme will stop the dryer and have the following effects.

Note: The Start/Pause Light flashes Amber during the Post

Care phase of a programme.

• During a delay phase the delay will continue to count

down. The start button must be pressed to resume the

delay programme. One of the delay lights will flash to

show the current delay setting.

• The start button must be pressed to resume the

programme. The progress lights will change to show the

current status and the Start/Pause light will stop flashing

and turn green.

• During the post creasecare phase of a drying program,

the Programme will finish. Pressing the Start/Pause

button will restart a new program at the beginning.

• Changing the Programmes knob will select a new

programme and the Start/Pause Light will flash green.

You can use this to select the “Refresh” programme to

cool the clothes if you find them dry enough. Pressing the

start/pause button to begin new Programme.

• Note

If you have a power cut, switch off the power or remove the

plug. When power is restored, plug in the machine, press and

hold the ON/OFF button until the dryer reactivates, then press

Start/Pause button.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Indesit AQC9 BF7 T1 (EX) Bedienungsanleitung Seite 48

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrische Wäschetrockner Indesit AQC9 BF7 T1 (EX)